Chapter 4 - Installing the Packard Bell
Compasseo in your car
Setting up the device
Please refer to the pictures on the following page and instructions below to set up your device correctly.
1. To assemble your car holder kit first attach the cradle to the suction-mount gooseneck. Ensure
that the 'CLOSE' arrow points in the direction you attach the cradle.
2. Place the car holder kit in a suitable location on your windscreen and release the clip at the base
of the gooseneck.
3. Push the clip back into place to fix the suction-mount gooseneck firmly to the windscreen.
4. Attach the Compasseo to the car holder kit: position the bottom of the Compasseo first, then tilt
the top of the Compasseo back into position. Pull the top clip until it clicks into place. Twist the
gooseneck to adjust the position of the Compasseo so that you can see the screen comfortably.
5. You can charge the Compasseo from your car using the supplied car adapter cable. For your
own safety and that of others, you should connect the cables only when your vehicle is
stationary. Connect the supplied USB cable to the USB port on the Compasseo and plug the
other end into the cigarette lighter. You can then start driving.
The Packard Bell Compasseo is now ready for use! Please read the instructions regarding Destinator
Navigates to know how to use your GPS.
CAUTION: Do not leave the device in your car. Exposure to sunlight may cause damage.
11
