163389

Panasonic cq-dfx683n Seite 17

17
Zoom out
Zoom in
Vorherige Seite
1/21
Nächste Seite
40 41
31
E
N
G
L
I
S
H
32
E
N
G
L
I
S
H
CQ-DFX683/DFX223/DFX213/DFX203NCQ-DFX683/DFX223/DFX213/DFX203N
Preliminary Steps
Check and take steps as described in the tables below.
If You Suspect Something Wrong
Immediately switch power off.
Disconnect the power cable and check that there is neither smoke
nor heat from the unit before asking for repairs. Never try to repair
the unit yourself because it is dangerous to do so.
Cautions:
¡ Do not use the unit if it malfunctions or
something is wrong.
¡ Do not use the unit in an irregular condition,
for example, without sound, or with smoke or
foul smell, which can cause ignition or elec-
tric shock. Immediately stop using the unit
and call the store where you purchased it.
Troubleshooting
Product Service
If the suggestions in the charts do not solve the problem, we recommend that you take it to your nearest authorized
Panasonic Service Center. The product should be serviced only by a qualified technician.
Problem Possible cause/Possible solution
■ Common
No power.
No sound.
Noise.
Demonstration mode is ON.
aPress [DISP] to cancel the demonstration mode.
aCheck that there is nothing causing radio interference with the machine.
Check the point where it is installed. Make sure that the ground lead is
properly grounded.
Condensation (dew).
aWait for a while before use.
External Mute lead is not correctly connected.
aConnect the External Mute lead correctly.
Cables are not correctly connected.
aConnect cables correctly.
Mute is set to ON.
aSet it to OFF.
Fuse is burnt.
a
Call the store where you purchased the unit, or your nearest Panasonic
Service Center
.
Cables are not correctly connected.
aConnect cables correctly.
Battery cable: Connect the battery cable to the terminal that is always live.
Accessory cable: Connect the accessory cable to your car's ACC source.
Grounding wire: Connect the grounding wire to a metal part of your car.
Car’s engine switch is not on.
aTurn your car’s ignition switch to ACC or ON.
Audio sound is output
but the display shows
demonstration message.
Problem Possible cause/Possible solution
Battery cable is not correctly connected.
aConnect the battery cable to the terminal that is always live.
The motor antenna relay control lead is not connected correctly.
aIf there is a motor antenna in the car, connect the motor antenna relay
control lead to the motor antenna lead that is installed in the car correctly.
aCheck that the antenna was installed and grounded properly.
Station is too far, or signals are too weak.
aSelect other stations of higher signal level.
Poor reception in FM
stereo and monaural
broadcasts.
Preset station is reset.
■ Radio
Problem Possible cause/Possible solution
¡CD is defective.
¡Mechanical trouble.
aOpen the panel and press [u]. If normal operation is not restored, call
the store where you purchased the unit or the nearest Panasonic Service
Center to ask for repairs.
Unstable mounting.
aCheck that the machine is properly installed with its rear fixed securely to
a firewall.
Mounting angle is over 30 degrees.
aAdjust mounting angle to less than 30 degrees.
aSome CD-R/RWs can not be played back successfully thanks to
incompatibility among writing software, a CD recorder (CD-R/RW drive)
and the discs. Refer to instructions for the concerned devices for details.
Disc is dirty.
aClean disc, referring to the section on
“
Notes on CD/CD Media (CD-R, CD-
RW, CD-ROM)
”
(
a Page 39).
aSome CD-R/RWs can not be played back successfully thanks to
incompatibility among writing software, a CD recorder (CD-R/RW drive)
and the discs. Refer to instructions for the concerned devices for details.
A disc that has data other than CD-DA or MP3/WMA type is loaded.
aDiscs that have CD-DA or MP3/WMA type data should be used.
Disc is dirty.
aClean disc, referring to the section on
“
Notes on CD/CD Media (CD-R, CD-
RW, CD-ROM)
”
(
a Page 39).
Disc is upside down.
aPlace disc in the correct direction with the label side up.
Disc is in the CD com-
partment but no sound
is made, or disc is
ejected automatically.
Sound skips, bad
sound quality. (e.g.
caused by noise)
Sound skip due to
vibration.
■ CD/MP3/WMA
Disc is not ejected.
… 17 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Panasonic cq-dfx683n wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info