Bedienungsanleitung Panasonic NVGX7B (Seite 7 von 52) (Englisch)

627465

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Before Use

-7-

≥Insert the plug securely into the [REMOTE] Socket as

far as it will goes. A loose connection will spoil normal

operation.

The Remote Controller

Inserting a Button-type Battery

Before using the Remote Controller, insert the supplied

button-type battery.

While pressing the Stopper 1, pull out the Battery

Holder.

Insert the button-type battery with the (i) marking

facing upward.

Insert the Battery Holder into the Remote Controller.

≥When the button-type battery is exhausted, replace it with a

new CR2025 battery. (A battery is normally expected to last

about 1 year. However, it depends on operation

frequency.)

≥Make sure to match the poles correctly when inserting the

battery.

WARNING

“THE LITHIUM BATTERY IS A CRITICAL COMPONENT

(TYPE NUMBER CR2025 MANUFACTURED BY

PANASONIC).

IT MUST NEVER BE SUBJECTED TO EXCESSIVE HEAT

OR DISCHARGE. IT MUST THEREFORE ONLY BE

FITTED IN EQUIPMENT DESIGNED SPECIFICALLY FOR

ITS USE.

REPLACEMENT BATTERIES MUST BE OF THE SAME

TYPE AND MANUFACTURER.

THEY MUST BE FITTED IN THE SAME MANNER AND

LOCATION AS THE ORIGINAL BATTERY, WITH THE

CORRECT POLARITY CONNECTIONS OBSERVED.

DO NOT ATTEMPT TO RE-CHARGE THE OLD BATTERY

OR RE-USE IT FOR ANY OTHER PURPOSE. IT SHOULD

BE DISPOSED OF IN WASTE PRODUCTS DESTINED

FOR BURIAL RATHER THAN INCINERATION.”

Using the Remote Controller

Direct the Remote Controller to the Remote Control

Sensor

(37)

of the Movie Camera and press an

appropriate button.

≥Distance from the Movie Camera: Within approximately

5 metres

≥Angle: Within approximately 15o in the vertical and

horizontal directions from the central axis

15˚

(37)

≥The above operative ranges are for indoor use. Outdoors

or under strong light, the Movie Camera may not operate

properly even within the above ranges.

≥Within a 1-metre range, you can also use the Remote

Controller on the LCD Monitor side of the Movie Camera.

Selecting Remote Controller Modes

When 2 Movie Cameras are used simultaneously, they can

be operated individually by selecting different Remote

Controller Modes.

≥If the Remote Controller Mode of the Movie Camera and

that of the Remote Controller do not match, [REMOTE]

Indication is displayed.

Setup on the Movie Camera:

Set [REMOTE] on the [OTHER FUNCTIONS] Sub-Menu to

the desired Remote Controller Mode. (

-10-

)

Setup on the Remote Controller:

[VCR1]:

Press the [D] Button and [∫] Button simultaneously. 1

[VCR2]:

Press the [E] Button and [∫] Button simultaneously. 2

≥When the battery in the Remote Controller is replaced, the

mode is automatically reset to [VCR1] Mode.

Power Supply

Using the AC Adaptor

Connect the DC Input Lead to the Movie Camera.

Connect the DC Input Lead to the AC Adaptor.

Connect the AC Mains Lead to the AC Adaptor and the

AC mains socket.

≥The AC Mains Lead’s outlet plug does not fit entirely into

the AC Adaptor socket. A gap will remain as shown 1.

≥Before connecting or disconnecting the power supply,

set the [OFF/ON/MODE] Switch on the Movie Camera to

[OFF] and make sure that neither [CAMERA/VCR/

CARD P.B] Lamps nor Quick Start Recording Lamp is

lit.

Using the Battery

Before use, fully charge the Battery.

Attach the Battery to the AC Adaptor and charge it.

INDEX INDEX

SELECT

STOP

∫

STILL ADV

PAU SE

STILL ADV

61 5

;

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic NVGX7B Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info