Bedienungsanleitung Panasonic NVMX500EG (Seite 7 von 11) (Englisch)

627478

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

Before Use

-7-

This controller allows the Movie Camera to be used more

conveniently by a left-handed user.

(86) Recording Start/Stop Button [REC]

(87) Zoom Lever [W/T]

(88) Photoshot Button [PHOTO SHOT]

≥Insert the plug securely into the [REMOTE] Socket as

far as it will goes. A loose connection will spoil normal

operation.

The Remote Controller

ª Inserting a Button-type Battery

Before using the Remote Controller, insert the supplied

button-type battery.

1 While pressing the Stopper 1, pull out the Battery

Holder.

2 Insert the button-type battery with the (i) marking

facing upward.

3 Insert the Battery Holder into the Remote Controller.

≥When the button-type battery is exhausted, replace it with a

new CR2025 battery. (A battery is normally expected to last

about 1 year. However, it depends on operation

frequency.)

(86)

(87)

(88)

≥Make sure to match the poles correctly when inserting the

battery.

ª Using the Remote Controller

1 Direct the Remote Controller to the Remote Control

Sensor

(48) of the Movie Camera and press an

appropriate button.

≥Distance from the Movie Camera: Within approximately

5 metres

≥Angle: Within approximately 5o in the upward, and 15o in

the downward and horizontal directions from the central

axis

≥The above operative ranges are for indoor use. Outdoors

or under strong light, the Movie Camera may not operate

properly even within the above ranges.

≥Within a 1-metre range, you can also use the Remote

Controller on the LCD Monitor side of the Movie Camera.

Selecting Remote Controller Modes

When 2 Movie Cameras are used simultaneously, they can

be operated individually by selecting different Remote

Controller Modes.

≥If the Remote Controller Mode of the Movie Camera and

that of the Remote Controller do not match, [REMOTE]

Indication is displayed.

Setup on the Movie Camera:

Set [REMOTE] on the [OTHER FUNCTIONS] Sub-Menu to

the desired Remote Controller Mode. (

-12-)

Setup on the Remote Controller:

[VCR1]:

Press the [D] Button and [∫] Button simultaneously. 1

[VCR2]:

Press the [E] Button and [∫] Button simultaneously. 2

WARNING

“THE LITHIUM BATTERY IS A CRITICAL

COMPONENT (TYPE NUMBER CR2025

MANUFACTURED BY PANASONIC).

IT MUST NEVER BE SUBJECTED TO

EXCESSIVE HEAT OR DISCHARGE. IT

MUST THEREFORE ONLY BE FITTED IN

EQUIPMENT DESIGNED SPECIFICALLY

FOR ITS USE.

REPLACEMENT BATTERIES MUST BE OF

THE SAME TYPE AND MANUFACTURER.

THEY MUST BE FITTED IN THE SAME

MANNER AND LOCATION AS THE

ORIGINAL BATTERY, WITH THE

CORRECT POLARITY CONNECTIONS

OBSERVED.

DO NOT ATTEMPT TO RE-CHARGE THE

OLD BATTERY OR RE-USE IT FOR ANY

OTHER PURPOSE. IT SHOULD BE

DISPOSED OF IN WASTE PRODUCTS

DESTINED FOR BURIAL RATHER THAN

INCINERATION.”

5˚

15˚

(48)

INDEX INDEX

SELECT

STOP

∫

STILL ADV

PAUSE

STILL ADV

61 5

;

B5-B.book 7 ページ２００２年８月６日　火曜日　午前１１時３３分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic NVMX500EG Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic NVMX500EG

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info