618347
36
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
RQTX0151
36
Problem Possible solution Pages
Common problems
No power. Ensure the AC mains lead is connected. 22
No sound or image after
playback starts.
Select the correct source.
Turn the muting off.
Check that the digital signals can be decoded by this system.
Cannot playback PCM signal with sampling frequency over 96 kHz.
Check connections to other equipment.
Set “DIG ” or “ANLG ” in “Setting input signals”.
Set “AUTO” in “Setting input signals”.
Turn this system off then on again.
24, 25
29
37
16 to 21
33
33
The remote control does not
work.
Replace the batteries if they are worn. 9
The standby indicator lights
up even if the system turned
off.
When you connect the AC mains lead to the household mains socket, the
standby indicator lights up while the system is off. When you turn the system
on, the indicator goes off.
22
No sound from microphone
connected to DVD player
(karaoke).
No sound output from microphone if connection to this system is digital. Change
to analogue connection and input. Make analogue connection to AUX3.
19
There is no DTS audio
output. There is audio
output, but the DTS decoder
indicator is not lit.
Set the DTS Digital Audio Output setting on the DVD player, Blu-ray Disc player
or DVD recorder to “Bitstream”.
Set “DTS” in “Setting input signals”.
33
Sound is not heard when
playing DVD audio.
This may occur due to digital copyright protection of the disc if using digital
connection. This system may not be able to play sources with sampling frequency
over 48 kHz.
Sound stops.
(“F61” appears on the
display for about a second.)
The protection circuit
activates when some
abnormality is detected,
and turns off the system
automatically.
Straining of the speakers through excessive volume or power.
This may occur if you use the system in an extremely hot environment.
Curtains or other objects may be blocking the exhaust hole.
D
Determine and correct the cause, then turn the system on.
(The protection circuit is reset.)
(Consult your dealer if the problem persists.)
“F70  appears on
the display.
(“DSP” or “HDMI” is
displayed in place of .)
Turn off the system, unplug the AC mains lead, and consult your dealer.
“F76” appears on the
display.
(After display, the system
turns off.)
Disconnect the AC mains lead, and consult your dealer.
Sound eld
No sound in surround mode. Set to Dolby Virtual Speaker, Dolby Pro Logic or SFC. 26, 27
Cannot use Dolby Virtual
Speaker, Dolby Pro Logic
or SFC.
You cannot use these features with PCM signals with sampling frequency over
48 kHz. Make analogue connection to AUX3.
You cannot use for Dolby Digital dual sounds.
19
32
HDMI
When using an HDMI
connection, the first few
seconds of sound is cut off.
This may occur if you start play from a chapter on a DVD. The following will
correct the problem.
1
Change the audio output setting on the Blu-ray Disc player, DVD recorder or
DVD player from “Bitstream” to “PCM”.
2
Change input signal setting to “PCM” in “Setting input signals”.
33
The system does not work
properly.
The system does not work properly if you have connected the HDMI input and
output terminals incorrectly. Turn the system off, unplug the AC mains lead, and
make the connections again.
17
Reference
Troubleshooting guide
Before requesting service, make the following checks.
If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem,
consult your dealer for instructions.
Troubleshooting guide
36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Panasonic SCHTR310 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Panasonic SCHTR310

Panasonic SCHTR310 Bedienungsanleitung - Deutsch - 120 seiten

Panasonic SCHTR310 Bedienungsanleitung - Englisch - 40 seiten

Panasonic SCHTR310 Bedienungsanleitung - Holländisch - 80 seiten

Panasonic SCHTR310 Bedienungsanleitung - Französisch, Italienisch - 120 seiten

Panasonic SCHTR310 Bedienungsanleitung - Spanisch - 80 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info