Bedienungsanleitung Parkside PSBM 500 A2 - IAN 93163 (Seite 7 von 58) (Dänisch, Französisch, Schwedisch)

576767

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

7 GB/IE

Introduction Introduction / General safety advice for electrical power tools

emission value speciﬁed can also serve as a prelim-

inary assessment of the exposure. The vibration level

will change according to the application of the elec-

trical tool an in some cases may exceed the value

speciﬁed in these instructions. Regularly using the

electric tool in such a way may make it easy to un-

derestimate the vibration.

Note: If you wish to make an accurate assessment

of the vibration loads experienced during a particu-

lar period of working, you should also take into

account the intervening periods of time when the

device is switched oﬀ or is running but is not actual-

ly in use. This can result in a much lower vibration

load over the whole of the period of working.

General safety advice for elec-

trical power tools

Read all the safe-

ty advice and instructions! Failure

to observe the safety advice and instruc-

tions may result in electric shock, ﬁre and /

or serious injury.

Keep all the safety advice and instructions

in a safe place for future reference!

The term “electrical tool” used in the safety advice

refers to electrical tools powered by mains electricity

(by means of a mains lead) and electrical tools

mains lead).

Workplace safety

a) Keep your working area clean and

well lit. Untidy or poorly lit working areas

can lead to accidents.

b) Do not work with the device in poten-

tially explosive environments in which

there are inflammable liquids, gases

or dusts. Electrical power tools create sparks,

which can ignite dusts or fumes.

c) Keep children and other people away

while you are operating the electrical

tool. Distractions can cause you to lose con-

trol of the device.

Electrical safety

The mains plug on the device must match

the mains socket. The plug must not be

modified in any way. Do not use an

adapter plug with devices fitted with

a protective earth. Unmodiﬁed plugs and

matching sockets reduce the risk of electric shock.

b) Avoid touching earthed surfaces such

as pipes, radiators, ovens and refrig-

erators with any part of your body.

There is an increased risk of electric shock if

your body is earthed.

c) Keep the device away from rain or

moisture. Water entering an electrical device

increases the risk of electric shock.

d) Do not use the mains lead for any pur-

pose for which it was not intended, e.g.

to carry the device, to hang up the de-

vice or to pull the mains plug out of the

mains socket. Keep the mains lead

away from heat, oil, sharp edges or

moving parts of the device. Damaged

or tangled mains leads increase the risk of

electric shock.

e) When working outdoors with an

electrical power tool always use ex-

tension cables that are also approved

for use outdoors. The use of an extension

cable suitable for outdoor use reduces the risk

of electric shock.

f) Use a residual current device (RCD)

for protection if operating the electri-

cal power tool in a moist environment

is unavoidable. The use of an RCD reduces

the risk of electric shock.

3. Personal safety

a) Remain alert at all times, watch what

you are doing and always proceed

with caution. Do not use the device if

you are tired or under the influence of

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Parkside PSBM 500 A2 - IAN 93163 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Parkside PSBM 500 A2 - IAN 93163

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info