89
installation guide
Space to be left free around the appliance
Fitting the hob
A certain height under the worktop is necessary if the hob is installed above an
oven. This height under the worktop depends on the following:
- Worktop thickness;
- Installed height of the hob (see table);
- Height of oven at highest point (not including the operating panel).
The required height under the worktop is the height of the oven at the highest
point plus the installed height of the hob less the worktop thickness.
Stick the sealing tape on the underside of the
edge or the glass top.
Don't stick the sealing tape around the corner;
rather cut four pieces to fit effectively in the
corners.
min. 600 mm
min. 650 mm
min. 450 mm
min. 40 mm
min. 40 mm
88
installation guide
Built in (CKV720)
Electrical connection
The power supply to the hob is via the oven or the separate operating panel.
Refer to the installation instructions for the oven concerned or the operating
panel.
Power setting table
Cut opening in worktop
Saw the opening in the worktop. This should be done very accurately (see
table). Also saw out any partitions that may be present. The distance from the
saw line to the rear wall and/or side wall is indicated in the table.
Table
Type of hob CKV720
Cooklight
x
Electrical connection 230 V - 50 Hz
Power of element
Front left double 2200 / 1000 W
Rear left 1200 W
Rear right 2000 W
Front right 1200 W
Type of hob CKV720
Appliance width x depth 575 x 505 mm
Installation height from top of worktop 56 mm
Cut out dimensions width x depth 560 x 490 mm
Distance from saw line to rear wall 50 mm
Distance from saw line to side wall 50 mm
