Bedienungsanleitung Perel WHPC01 (Seite 4 von 32) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

492082

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

WHPC01 Rev 03

27.04.2010 ©Velleman nv

• Do not operate the pressure cleaner with the inlet water screen removed. Keep the screen clear of debris and

sediment.

• NEVER operate the pressure cleaner with broken or missing parts. Check the unit regularly and have worn or

damaged parts replaced immediately.

• Use only the nozzle supplied with this machine.

• Never leave the wand unattended while the machine is running.

• Never attempt to alter factory settings. Altering factory settings could damage the unit and will void the

warranty.

• Always hold the gun and wand firmly when starting and operating the machine.

• NEVER allow the unit to run for more than one (1) minute without spraying water. The resulting heat build-up

will damage the pump.

• The pressure cleaner is not meant to pump hot water. NEVER connect it to a hot water supply as it will

significantly reduce the life of the pump.

• NEVER store the pressure cleaner outdoors or where it could freeze. This would seriously damage the pump.

• Release the trigger when you want to change the pressure setting. Failure to do so could result in damage.

• Install an additional sand filter (not incl.) when using water from a different source than the potable water

mains.

CAUTION

• Keep the hose away from sharp objects. Bursting hoses may cause injury. Examine the hose regularly and

replace it if damaged. Do not attempt to repair a damaged hose.

DANGER: EXTENSION CORDS

• Use only grounded three-wire extension cords that are in good condition.

• Use of an extension cord is not recommended. Use only extension cords intended for outdoor use.

• Use only extension cords with an electrical rating equal to or higher than the rating of the device.

• Examine the extension cord prior to use and replace it if damaged.

• Do not pull on the cord to disconnect the device from the mains; pull the plug instead.

• Keep the cord away from heat and sharp edges.

• Always disconnect the cord from the receptacle before disconnecting the device from the extension cord.

• Failure to follow these instructions can result in serious injury, including death.

• Keep all connections dry and off the ground to reduce the risk of electrocution. Do not touch plug with wet

hands.

3. Features

• ideal for thorough cleaning of stone, wood, metal and plastic materials

• with automatic motor shut-off

• comes with:

o 5 m high-pressure hose

o soap dispenser bottle

o high-pressure lance with adjustable nozzle and spray gun

• optional hard surface cleaner (not incl.): WHPCBR

4. Connection

Refer to illustration A on page 2 of this manual.

1 pressure cleaner 6 water outlet

2 water supply hose (not incl.) 7 trigger gun

3 water connection 8 power supply

4 water inlet 9 wand with spray nozzle

5 high-pressure tube 10 ON/OFF switch

How to mount your high-pressure cleaner:

• Mount the spray nozzle on the trigger gun

• Attach the spray handle to the high-pressure hose. Prior to operating the machine please ensure that the high-

pressure hose has been completely uncoiled. Make sure the hose DOESN’T loop during operation.

• Attach the high-pressure hose to the unit’s pressure water outlet.

• Connect the machine to the water and power supplies. Use an inlet hose (not incl.) of at least 1m long and

capable of withstanding a pressure of 0.8MPa.

5. Preparations

Adjusting the Fan Pattern

• The angle of the spray coming out of the lance may be adjusted on some lances by rotating the nozzle. This

will vary the spray pattern from approximately a 0° high-impact stream to a 60° fan spray (see fig. B1).

• A narrow stream exerts a high impact force on the target surface and results in maximum deep cleaning in a

concentrated area. However, this narrow high- impact spray must be used cautiously, as it may damage some

surfaces (fig. B2).

• A wide fan pattern will distribute the impact of the water over a larger area, resulting in excellent cleaning

action with a reduced risk of surface damage (fig. B3).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Perel WHPC01 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info