Bedienungsanleitung Pet-Mate Cat-Mate 360 (Seite 3 von 12) (Deutsch, Englisch, Holländisch, Französisch, Spanisch)

782683

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

4 5

IMPORTANT:

• Do not cut tunnel (B, Fig. 1) of cat flap.

• To check that your cat’s microchip is correctly positioned and functioning, we

strongly recommend you program the cat flap for all your cats before

installation (see Section 3). Then check the cat’s microchip operates the catch

(C, Fig. 1) when the cat’s head is pushed gently against the flap as shown

in Fig. 2.

• For UPVC / metal doors thicker than 35mm (13/8”) use a Cat Mate Cat Flap

Adapter Kit (Ref. 361).

• For UPVC / metal doors it is essential to retune the cat flap after fitting

(see Section 8).

1. Introduction

Thank you for choosing the Cat Mate Microchip Cat Flap.

The Cat Mate Microchip Cat Flap allows entry for up to 30 cats into your property. It

also allows you to control the exit of all your pets using a 4 way lock.

This cat flap is suitable for all popular microchips. Alternatively it may be operated by

a Cat Mate I.D. Disc (available separately). You may wish to use an I.D. Disc for cats

without a microchip or in the event that your cat’s microchip is faulty or poorly

positioned.

2. Fitting the Batteries

2.1 Remove the battery cover by pushing the battery cover upwards (see Fig. 3).

2.2 Insert 4 x AA (R6) batteries using the orientation symbols marked on the inside of

the battery compartment. Partially replace battery cover to leave PROGRAM

button (G, Fig. 1) exposed for programming.

2.3 The cat flap will self check for up to 30 seconds and then the flap is ready to

program.

All popular batteries can be used including rechargeable batteries, but the battery

warning (Section 6) will only work correctly with alkaline batteries. Good quality

alkaline batteries should last approximately 12 months (depending on number of cats

and usage). You MUST NOT use lithium batteries.

3. Programming

Program your cat’s microchip or I.D. Disc(s) as follows:

3.1 Press and hold the PROGRAM button (G, Fig. 1) for 5 seconds until the

LED (A) illuminates. Wait a minimum of 10 seconds.

3.2 To program your cat’s microchip, encourage your cat to slowly pass through the

tunnel by holding the flap open as shown in Fig. 4 after checking the rotary 4 way

lock (D) is set to IN & OUT. To program an I.D. Disc, place in tunnel opening as

shown in Fig. 5.

3.3 When programmed, the LED will flash.

3.4 Press the 'PROGRAM' button to save the setting.

For additional cats, up to a maximum of 30, repeat steps 3.1 to 3.4.

NOTE: If you attempt to program more than 30 microchips / I.D. Discs, the LED

will flash. If this occurs perform a FACTORY RESET (Section 7) and reprogram

microchips / I.D. Discs in current use.

4. Access Options

Once your cat(s) microchip(s) / I.D. Disc(s) are programmed, the access options

available with the rotary 4 way lock are:

'In & Out' Your cat(s) can come in and out of the flap

'In Only' Your cat(s) can come in through the flap but cannot leave

through the flap

'Out Only' Cat(s) can go out through the flap but cannot enter through

the flap

'Locked' Cat(s) cannot use the flap

5. Training Your Cat to Use the Cat Flap or if Your Cat Has Lost its I.D. Disc

It may take a little time for your cat to get used to its new cat flap. To help your cat

get used to entering and exiting the flap, the flap can be set to TRAINING MODE

as follows:

5.1 Remove one battery for 60 seconds.

5.2 Replace battery and wait until interior lock (C) drops after approximately

5 seconds.

5.3 Remove battery within 5 seconds before lock is reactivated and replace battery

cover.

Please be aware that in TRAINING MODE your cat flap will allow access for

other animals.

To exit the TRAINING MODE, simply reinstall all batteries.

NOTE: We do NOT recommend that cats, particularly kittens, are left alone to use their

cat flap until you are satisfied that they are completely familiar with its operation.

6. Battery Replacement

When the LED flashes every 30 seconds, alkaline batteries should be replaced

(See Section 2).

Please note, after fitting new batteries the Battery warning may take up to 15 minutes

to disappear.

7. Factory Reset

To erase all programmed microchips / I.D. Discs, press and hold the 'PROGRAM'

button for 30 seconds until LED flashes. After a further 30 seconds you may

re-programme microchip(s) / I.D. Disc(s) (See Section 3).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pet-Mate Cat-Mate 360 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info