300239
26
Zoom out
Zoom in
Vorherige Seite
1/27
Nächste Seite
Troubleshooting
25
Troubleshooting
The icon is not blinking
when the handset is placed on
the base
PROBLEMS
No dialling tone
Crackling on the line
The handset displays ‘not
available’
- when attempting to add
another handset to the base
station
- when using a handset
Noise interference on your radio
or television
Caller Line Identification (CLI)
service does not work
No ring tone
The icon does not appear
The icon is blinking
- Bad battery contact
- Dirty contact
- Battery is full
CAUSES
- No power
- Batteries are empty
- You are too far from the base station
- Wrong line cable
- Line adaptor (when needed) not
connected to the line cord
- The ring tone is deactivated
- No mains power
- The handset is too far from the
base station
- Handset not registered to the
base station
- You are too far from the base
station
- The base station is too close to
electrical appliances, reinforced
concrete walls or metal
doorframes
- The procedure to add a handset
has failed, try again
- Maximum number of handsets
(5) has been reached
- Base station is already busy with
another handset
The DECT 122 base station or
mains power pack are too close
to electrical appliances
- The service is not activated
- Move the handset slightly
- Clean the contact with a cloth
moistened with alcohol
- No need to charge
SOLUTIONS
- Check the connections.
Reset the phone : unplug and
plug back in the mains
- Charge the batteries at least 24
hours
- Move closer to the base station
- Always use the line cable
provided
- Connect the line adaptor (when
needed) to the line cord
- Increase the volume (page 18)
- Check connections
- Move closer to the base station
- Register the handset to the
base (page 22)
- Move closer to the base station
- Move the base station to find a
better place (the higher the
better)
- Disconnect and connect the
base station power supply.
- Remove and place back the
handset battery
- Follow the procedure to
register a handset (page 22)
- Unregister a handset
- Wait until it is available
Move the power pack or base
station as far away as possible
- Check your subscription with
your network operator
Telephone troubleshooting
www.philips.com/support
A phonebook entry cannot be
stored
The phonebook is full
Delete an entry to free memory
DECT122_GBIE_09.qxd 27.09.2005 17:06 Seite 25
26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Philips dect 122 quattro wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Philips dect 122 quattro

Philips dect 122 quattro Bedienungsanleitung - Deutsch - 27 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info