PUNCH-THROUGH SOUND
Punch-through sound enables you to control the audio level of
your TV, regardless of what device mode the remote control is in.
POWER/DIGIT TOGGLE
Even when your TV can be activated by using a digit key only
(e.g. digit number 1) instead of using the power key, you need
to install the "Power/Digit Toggle" function. After you installed
this function, the power key will send out the "power on/off"
code, the first time you press the "power" key and the "digit
1" code when you press the "power" key for the second time.
In this way it is possible to activate your TV even when it
responds to digit codes only. To install this "Power/Digit
Toggle" function, follow the following procedure:
1 Look up the "Power/Digit toggle" code in the code list
(centre of this manual).
2 Make sure the remote control is in the TV mode.
3 Press and hold power and mute keys simultaneously – for
about three seconds – until the green LED lights up.
(Release the keys: the green LED should stay on).
4 Enter the 6 digit "Power toggle" code within 30 seconds.
– The green LED flashes twice.
Follow the same procedure to cancel the "Power/Digit toggle"
function.
TROUBLESHOOTING GUIDE
• Problem:
– Solution:
• Equipment is not responding and the green light does not
flash when you press a button.
– Replace batteries with two new 1.5 volt, type RO3, UM4 or
AAA batteries.
• Equipment is not responding, but the green light does flash
when you press a button.
– Aim the SBC RU130 at the equipment and be sure that there
are no obstructions between the SBC RU130 and the
equipment.
• The SBC RU130 is not performing commands properly.
– You may be using the wrong code. Try repeating Set up using
another code, listed under your brand, or start the Autosearch
Set-up over again to locate the proper code.
If the equipment still doesn’t respond, call the help-line and
we’ll put you back on track.
• Your brand is not listed in the code list.
– Try the Autosearch method.
Instructions for use
5
English
