5
RU240- page 5
NOTE:
The RU460 can be programmed entirely to your needs. With the RU460
you can copy functions from any combination of devices, and allocate
them to any mode you want. You can for instance copy functions from
the remote control of your second VCR under AUDIO2, or you can copy
functions from your DVD remote control under SAT/CBL.
Place the top of your original remote
control so that it’s facing the infrared
sensor window of the RU460. Place both
remote controls on a flat surface and 3-8
centimeters apart. Make sure that both
remote controls have fresh batteries.
To copy codes from your original remote control
Press and hold and at the same time -for about 3 seconds-
until the green LED on the RU460 lights up. (Release the keys, the
green LED should stay on)
1 Press a key on the RU460 that you want to copy a function of your
original remote under, the green LED blinks once, indicating that
the RU460 is ready to receive a signal.
2 Press and hold the key on your original remote control that you
want to copy to the RU460, until the green LED on the RU460
blinks three times and stays off. Release the key, the function for
the selected key has now been copied.
That’s it ! You’ve now copied a function in the RU460, this key is now
ready to transmit the same function as your original remote control. If
you want to copy more functions from your original remote control,
start again from step 1.
Tip: Choose keys that correspond with the keys on your original remote
control, so that you can remember them easily.
If all LEDs blink once the RU460 did not receive the signal correctly,
– make sure that the remotes are correctly positioned and try again
from step 3.
– Make sure that both remotes have fresh batteries.
– try to copy your codes in different light conditions. Light from TL-
tubes may influence the signal you are learning.
NOTE:
In the rare instance that the RU460 does not respond at all or stops
working, please remove the batteries. Insert the batteries after 2
seconds, the remote should be back in normal operation mode.
Our RU460 is designed and tested extensively and is ready to copy
almost all infrared remote control signals. In some rare instances
manufacturers use infrared signals that cannot be copied into any
remote control. But please try the Handsfree Autosearch to see if this
code is included in our pre-programmed library.
If you run out of keys on the RU460, or if you want to copy less
important functions, you can copy them under shift. Here’s how:
Make sure you’re in the right mode for the equipment you’re setting up
and position the remotes as indicated above.
1 Press and hold and at the same time -for about 3
seconds- until the green LED of the RU460 lights up. (Release the
keys, the green LED should stay on)
2 First press and hold and then press the key on the RU460 that
you want to copy a function from your original remote under, the
green LED blinks once, indicating that the RU460 is ready to
receive a signal. Release both keys.
