5 When your TV switches off (stand-by), release the Standby key of the
SRU520 immediately.
– The SRU520 has now found a code that works on your TV.
6 Check if you can operate all functions on your TV with the SRU520.
• If this is not the case, you can redo the automatic setting.
The SRU520 will then search for a code that works better.
– After the SRU520 has run through all the known codes,
the search will stop automatically and the TV button stops flashing.
– Automatic programming of a TV takes a maximum of 5 minutes. For
VCR/DVD this time is 2 minutes.
Manually setting the remote control
Example of TV:
1 Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2 Look up the brand of your TV in the
code list at the back of this manual. One or
more four-figure codes are shown for each
brand. Note the first code.
Be careful! There are separate tables for TV,VCR
and DVD.
On our website www.philips.com/urc you can directly select your device
typenumber to find the right code.
Make sure you use the codes from the correct table.
3 Press the TV key to select TV. Press the key
until it lights up.
4 Keep keys 1 and 3 pressed simultaneously
for three seconds until the TV key flashes
twice and then remains lit.
5 Then enter the code noted in step 2 using the digit keys.
– The TV key will now flash twice.
If the key flashes once for an extended period, the code has not been
entered properly or the wrong code has been entered.
Start again from step 2.
6 Point the SRU520 at the TV and check that it responds as it should.
– If the TV responds to all of the key commands, the SRU520 is ready for
use. Do not forget to note your code.
• If the device does not respond at all, or not to all of the
key commands, start again from step 2 and try the next code
from the list.
6
Instructions for use
English
