Bedienungsanleitung Pioneer VSX-D710S (Seite 50 von 52) (Englisch)

455271

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Additional Information

The power does not turn on.

• Connect the power plug to the wall outlet.

• Disconnect the power plug from the outlet, and insert

again.

• Make sure there are no loose strands of speaker wire

touching the rear panel. This could cause the receiver

to shut off automatically.

The unit does not respond when the buttons are

pressed.

No sound is output when a function is selected.

• Make sure the component is connected correctly

(refer to pages 5 to 14).

• Press MUTING on the remote control.

• Adjust MASTER VOLUME.

• Press the MONITOR button.

• Press SPEAKERS to select the speakers you

connected.

No image is output when a function is selected.

• Make sure the component is connected correctly

(refer to pages 5 to 14).

• Press the correct function button.

Considerable noise in radio broadcasts.

• Tune in the correct frequency.

• Connect the antenna (refer to page 10).

• Route 2 RF and digital cables away from the

antenna terminals and wires.

• Fully extend the FM wire antenna, position for best

reception, and secure to a wall.

• Connect an outdoor FM antenna (refer to page 10).

• Adjust the direction and position for best reception.

• Connect an additional internal or external AM

antenna (refer to page 10).

• Turn off the equipment causing the noise or move it

away from the receiver.

• Place the antenna farther away from the equipment

causing the noise.

Broadcast stations cannot be selected automatically.

• Connect an outdoor antenna (refer to page 10).

No sound from surround or center speakers.

• Refer to “SPEAKERS setting mode” on page 16 to

check the speaker settings.

• Refer to “Setting the volume level of each channel” on

page 20 to check the speaker levels.

• Connect the speakers (refer to page 11-13).

• Make sure that both A and B sets of speakers are not

switched on at the same time (A+B setting).

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with

this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other

components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks

listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work.

If the unit does not operate normally due to external

effects such as static electricity.

Disconnect the power plug from the outlet and insert

again to return to normal operating conditions.

Sound is produced from other components, but not

from LD or DVD player.

• Set SIGNAL SELECT to “DIGITAL” or “ANALOG”

according to the type of connections made (refer to

page 27).

• Set the digital input settings correctly (refer to pages

19).

• Make digital connections (refer to page 5-6) and set

SIGNAL SELECT to “DIGITAL” (refer to page 27).

• Refer to the instruction manual supplied with the

DVD player.

No audio is output when software with DTS is

played back.

• Make sure your DVD is digitally connected to this

receiver (refer to page 5-6) and set the SIGNAL

SELECT to “DIGITAL”.

When a search is performed by a DTS compatible

CD player during playback, noise is output.

• This is not a malfunction, but be sure to turn the

volume down to prevent the output of loud noise

from your speakers.

Cannot be remote controlled.

• Replace the batteries (refer to page 4).

• Operate within 7 m, 30° of the remote sensor on the

front panel (refer to page 4).

• Remove the obstacle or operate from another

position.

• Avoid exposing the remote sensor on the front panel

to direct light.

The display is dark or off.

• Press

FL DIMMER on the remote control repeatedly

to return to the default.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pioneer VSX-D710S Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Pioneer VSX-D710S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info