Bedienungsanleitung Polti Mondial VAP 4500 (Seite 14 von 15) (Englisch)

648789

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

the mains power.

• After using the brushes, leave the bristles

to cool down in their natural position in or-

der to prevent any deformations.

• Periodically check the condition of the ga-

skets located in the unit plug (6). If neces-

sary, replace them with an approved spare

part. Also check the connection gaskets of

the extension tubes (9) and handle (2).

Use a damp cloth to clean the outside. Do

not use solvents or detergents because

they could damage the plastic surfaces.

CLEANING THE DIRT

CONTAINER UNIT (M)

• Turn off the appliance from the main

switch (B) and disconnect the power cord

(A) from the mains power.

• Release the locking lever of the dirt contai-

ner (L) and slide the container unit (M) to-

wards the outside of the appliance (fig. 3).

• Lift the cover of the dirt container (O).

CLEANING THE EPA FILTER (R)

• Turn the EPA filter (R) in an anti-clockwise

direction and pull it so that it detaches

from the filter cover (O) (fig. 9).

• Rinse the EPA filter under running water to

remove any dirt.

• Allow the filter to dry before reconnecting it

to the cover (O).

ATTENTION:

• Do not clean the filter with brushes, rags

or any object which may exert an abrasive

action, because rubbing or buffering may

damage it and consequently reduce its fil-

tering performance.

• Do not use detergents, do not rub the filter

and do not wash it in a dishwasher.

• To continue working, reassemble the filter

by following the above operations in re-

verse. The filter has a lifecycle of about

100 hours.

CLEANING U-SHAPED TUBE (S)

• Separate the “U-shaped” tube (S) from the

cover and rinse under running water.

Make sure that the small tube positioned

on the bottom of the “U-shaped” tube is

not obstructed. If so, separate it from the

“U-shaped” tube and wash under running

water to remove any obstructions.

• When replacing the “U-shaped” tube on

the cover of the dirt container, make sure

to position it by aligning the indent on the

tube with the indent on the cover (fig. 10).

CLEANING THE FLOAT (P)

When cleaning the dirt container unit (M),

make sure there are no obstructions or dirt

inside the float compartment.

If the float and its cage require cleaning, pro-

ceed as follows:

• Open the cage of the float by working on

the two tabs and remove the cover of the

float (Q) (fig. 11).

• Remove the float.

• Clean the float compartment, the float and

the cover and remove any dirt.

• Repeat these operations in reverse to

close everything.

EMPTYING OF TANKS

(I and J)

The water tank (I) and detergent tank (J) can

be conveniently emptied. To empty the tanks

proceed as follows:

• Pull the tube closest to the tank to be ope-

ned out from its fixing clip and empty the

tank of its contents.

Once the tank has been emptied, replace

the tube (fig. 12).

MONDIAL VAP 4500

ENGLISH

M.V.4500 M0S103740 1S11:Layout 1 24/01/2013 14.50 Pagina 23

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Polti Mondial VAP 4500 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Polti Mondial VAP 4500

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info