Bedienungsanleitung Polti UNICO MCV50 (Seite 16 von 20) (Englisch)

649052

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

ENGLISH

| 30|

15. CLEANING THE BOILER

(extraordinary maintenance)

Use Allen key no. 6.

To maintain maximum performance, clean the boiler once per

year and/or every 50 intense uses.

15.1 Fully empty the tank and remove the dirt collector.

15.2 Put the appliance on its side and remove the lid using a coin.

15.3 Unscrew the boiler cap using Allen key no. 6.

15.4 Pour 200 ml of tap water into the boiler.

15.5 Rinse the boiler and pour the water into the sink or into a

special container for dirty water. If the water is very dirty,

repeat the operation until the water is clean.

15.6 Insert 200 ml of water in the boiler and screw on the cap,

ensuring the seal is present and that it is correctly screwed on.

Replace the lid.

15.7 Fill the water tank again and close the door.

15.8 Turn the appliance back on.

Before using steam to clean, direct the jet into a sink or other

container until the steam is completely clean.

16. CLEANING THE MINI TURBO BRUSH

(extraordinary maintenance)

16.1 Rotate the locknut and remove the upper part of the mini

turbo brush.

16.2 Clean the inside of the brush and re-close following the

procedure in reverse order.

17. CLEANING THE VACUUM TUBES

(extraordinary maintenance)

17.1 Switch on the appliance by pressing the power switch.

17.2 Vacuum 0.5l of clean water from a container and empty

the dirt collector.

17.3 Repeat the operation until the water in the dirt collector is

sufﬁciently clean.

17.4 With the dirt collector clean and dry, vacuum air for at least

5 minutes to completely dry the tubes.

17.5 Ensure that the dirt collector and ﬁlters are completely dry.

It is recommended that the tubes be cleaned every time the

ﬁlters are cleaned and after every intensive use of the product.

18. STORAGE

18.1 Turn off the appliance and disconnect from the mains

electricity.

18.2 Pull the power cable gently towards you to activate the

automatic winder, guiding it gently back into the appliance.

18.3 The hose and ﬂexible hose can be housed on the body of

the appliance, sliding the universal brush into the parking

system on the appliance.

Before storage, we advise quickly drying the ﬁlter and the

collector with a cloth to avoid unpleasant odours forming.

WARNING: Do not lift the appliance with the telescopic tube

and the brush in the parking position.

WARNING: Do not exceed the quantity of water indicated and

pour it slowly into the boiler, making sure not to let it overﬂow.

WARNING: Steam.

Risk of scalding!

WARNING: Risk of scalding! When accessing the boiler

(removing the cap, ﬁlling up, emptying), ensure that the

appliance is switched off at the power switch and

disconnected from the mains for at least two hours.

Manuale UNICO MCV50-MCV70 VERSIONE 16-09-14_vers7:UNICO 22/09/2014 16.19 Pagina 30

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Polti UNICO MCV50 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Polti UNICO MCV50

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info