Bedienungsanleitung Polti Vaporetto Flash (Seite 6 von 8) (Englisch)

648587

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

VAPORETTO FLASH

WARNINGS

• DO NOT USE ON leather, wood or delicate fabrics

especially dralon, velvet and other pile surfaces.

• For cleaning leather, wood or delicate fabrics

especially dralon, velvet and other pile surfaces,

consult the manufacturers instructions. Clean only

by using the hand gun at a safe distance together

with a soft cloth and always do a test on a non vi-

sible part of the item first or on a sample.

Allow the test area to dry completely before obser-

ving results and effects on surface or colour

before proceeding to clean further areas.

• For cleaning wood surfaces (furniture, doors etc.)

take great care as a too long application of the

steam could alter the waxed appearance, the

shine or the colour of the surfaces cleaned. We

therefore recommend you to apply the steam on

such surfaces only for brief periods or to clean

these surfaces using a cloth first held in the

steam.

• Please pay particular attention while cleaning

brick floors: a too long application of steam could

damage wax, brightness or colour of these surfa-

ces.

• For delicate surfaces (e.g. synthetic materials, lac-

quered surfaces etc.) we recommend that the

small brush should always be covered with at

least two cloths to reduce the intensity of the

steam, and (on machines with steam variation

control) with the steam set at low level. Always

test first on a non-visible area, allow to dry thorou-

ghly, and if successful, make sure to use exactly

the same tool, technique, steam level and steam

jet distance.

• If cleaning glass surfaces in particularly low tem-

peratures preheat the glass using the hand gun

from about 50 centimetres distance from the sur-

face to be cleaned.

• For care of your plants vaporise at a minimum di-

stance of 50 centimetres.

STEAM GUN (2)

The steam gun can be used directly on all spots re-

quiring a stronger, closer treatment without con-

necting the brushes. The more resistant the stain,

the closer you should hold the gun, the steam pres-

sure and temperature being higher at the source.

Always wipe with a dry cloth (or a slightly abrasive

sponge if the spot is a difficult one to remove) after

using the gun. Steam gun is particularly efficient at:

• breaking down rug and carpet stains before they

are treated with the large brush;

• cleaning stainless steel surfaces, panes, mirrors,

enamelled surfaces;

• cleaning hard-to-reach corners, such as stairs,

window sills, door posts;

• cleaning cooking top knobs, taps bases

• cleaning window shutters, heaters, car interiors;

• spraying plants (from a distance);

• removing odours and creases from clothes.

To reach higher points, the steam gun can be con-

nected to one or both extension tubes.

(

)

Connect the large brush connection (7) to the

large brush (8) as shown in the figure 6.

To clean floors, place the brush on the cotton cloth

(13), fix it in place with the lever hooks provided (9),

and move the appliance back and forth without ap-

plying pressure. When one side of the cloth is dirty,

turn it over. Use the brush without the cloth on parti-

cularly dirty areas or encrustations and to clean

between tiles, using a sideways movement to get

dirt out. Use the steam gun directly in hard-to-reach

corners and on stains, wiping them with the cloth

afterwards. On washable vertical surfaces or wall-

paper and on light fixtures, cover the brush with a

dry cloth and proceed in the same way as for the

floor. Use the cloth provided (13) or a terry cloth

(such as an old towel). To clean glass surfaces,

wrap the brush with a cotton cloth that will not leave

fluff behind, anchor it in place with the lever hooks

provided (9), and wipe it over the glass to remove

any grease and traces of cleaning products. Finish

by spraying with the steam gun and then drying the

surface. In particularly cold weather, preheat the

glass by spraying with steam from 50 cm away

before cleaning. VAPORETTO guarantees maxi-

mum hygiene and brightens up colours on synthetic

and wool rugs and carpets of all kinds on floors and

walls. Pass the brush over the surface without the

cloth to bring out dirt, cover the brush with a cotton

cloth held in place by the lever hooks provided (9),

and then go over the surface again to pick up the

dirt. You may fold the cloth over two or three times if

the carpet is particularly delicate. Work quickly and

without applying pressure to the carpet, moving the

brush forward, backwards and sideways without

stopping too long in the same place. This treatment

may be repeated as many times as you like without

damaging the surface of the carpet. If your carpet

is particularly dirty or saturated with cleaning pro-

ducts, don’t apply too much pressure, and don’t

worry: results will appear after you have used the

VT FLASH 1P09:VT 2300 M0S05357 1L05 15/09/2009 16.33 Pagina 29

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Polti Vaporetto Flash Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Polti Vaporetto Flash

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info