Bedienungsanleitung Polti Vaporetto Lecoaspira FAV30 (Seite 17 von 22) (Englisch)

648710

Zoom out

Zoom in

Vorherige Seite

1/22

Nächste Seite

| 33 |

17. CLEANING THE HEPA FILTER

(extraordinary maintenance)

17.1 Ensure that the appliance is switched off and disconnected

from the mains.

17.2 Lift the water filter collector removing it from its housing

using the container handle.

17.3 Lift the release lever of the HEPA filter and remove it from

its housing.

17.4 Rinse the HEPA filter using running water only and shake

gently to remove any excess dirt or water residue; before

replacing the filter in the appliance, leave to dry naturally away

from sources of heat for at least 24 hours.

The HEPA filter should be fully cleaned approximately three

times per year.

18. SPARE SEALS

Periodically check the status of the coloured washer located in

the built-in socket. If necessary, replace with the corresponding

spare part, as described below.

Perform the same check on the connection seals of the

extension tubes and the handle of the hose. If necessary,

operate as follows.

19. STORAGE

19.1 Turn off the appliance and disconnect from the mains

electricity.

19.2 Remove the water filter collector as indicated in Chapter 1.

19.3 Manually wind the cable evenly and replace it into the

holder, passing it into the power cable storage space.

19.4 Replace the water filter collector in its housing, making sure

to position it correctly.

19.5 The hoses, brush and flexible hose can be housed on the

body of the appliance, sliding the hook on the universal brush

into the parking system on the appliance.

The hook is present only on extension tubes. Incorrect

assembly of the two extension tubes will prevent the use of

the appliance parking system.

- Remove the damaged washer.

- Insert the new washer, applying it on the

steam nozzle and pushing it into place.

- Lubricate the gasket with silicone grease or

Vaseline, or alternatively with small quanti-

ties of vegetable oil.

- Remove the damaged washer.

- Insert the new washer, attaching it on the

steam nozzle and pushing it into place.

- Lubricate the gasket with silicone grease or

Vaseline, or alternatively with small quanti-

ties of vegetable oils.

To clean the water filter collector and the extension tubes, if

they are especially dirty, once the cleaning operations have

been completed, empty the container as described and

replace it in its housing in the machine. Connect the appliance

to the mains.

Then vacuum up approximately 1.5 litres of clean water using

the suction function for a few seconds. The water vortex

created inside the collector will rinse the sides and remove any

dirt. The clean water will also clean the inside of the tubes as

it travels through them. Empty the collector again and put

Vaporetto Lecoaspira away.

WARNING: Check the filters during cleaning. Replace the filters

when visibly damaged.

WARNING: Do not clean the filter with the brush as it can be

damaged, thereby reducing its filtering capacity. Do not use

detergents, do not rub the filter, and do not wash it in a

dishwasher.

ENGLISH

PRELIMINARE LECOASPIRA FAV20_30 - 2015_vers7:UNICO 22/04/2015 10.45 Pagina 33

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Polti Vaporetto Lecoaspira FAV30 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Polti Vaporetto Lecoaspira FAV30

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info