Bedienungsanleitung Powerplus POW63655 (Seite 7 von 9) (Englisch)

480882

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

POW63655

8 MAINTENANCE AND STORAGE

 Make sure all fasteners (screws, nuts, ect.) are always fully tightened so that you can work

safely with the mower.

 Check the grass box for wear and tear at regular intervals.

 Replace any worn or damaged parts.

 Regular care of your lawnmower will not only increase its service life but will also facilitate

the meticulous and easy mowing of your lawn.

 Clean the lawnmower with brushes or cloths. Do not use any solvents or water to remove

dirt.

 Always switch off the motor and pull out the power plug before carrying out any

maintenance and cleaning work.

 The part most susceptible to wear and tear in the machine is the blade. Check the

condition of the blade and its fastener at regular intervals. If the blade is worn, it must be

replaced or sharpened. If the mower vibrates excessively, this means that the blade is

either not balanced correctly or has been bent out of shape by knocks, in which case it

must be repaired or replaced.

8.1 The blade

 Always disconnect the power plug and check on the run-on display that the motor is off

before you inspect the blade. Remember that the blade will continue to rotate for a few

seconds even after the motor has been switched off. Never try to stop the blade. Make

sure at regular intervals that the blade is securely attached, in good condition and sharp.

Sharpen or replacement as and when necessary.

 If the blade strikes an object while mowing, stop the lawnmower and wait until the blade

has come to a standstill. Then check the condition of the blade and the blade fixing screw.

If these have been damaged or loose, they must be replaced immediately.

8.2 Replacing the blade

Wear safety gloves for this job !

Warning ! Always disconnect the power plug and check on the run

display that the motor is off before you inspect the blade.

 Loosen the plastic nut by turning anti-clockwise with a 35mm wrench, pull out the blade

and replace with a new one, making sure the direction of installation is correct (Fig.9).

Tighten the plastic nut of fixing screw by turning clockwise.

 At the end of the season, perform a general inspection of your lawnmower and remove

any grass and dirt which may have accumulated.

 At the start of each season, check the condition of the blade, the connection cable and all

electrical connections.

 If repairs are necessary, please contact one of our customer service centers.

 Use only original spare parts for maintenance work.

8.3 Storage

Always clean your mower before storage. Store your mower in a clean, dry environment.

To avoid mould on remaining contents, make sure the grass collect bag is empty and dry.

You can fold the handle to save space, loosen the 2 clamps on each side of the handle and

bend the upper handle part towards the front of the machine.

Long time storage : apply some environmentally friendly oil on the mower blade to prevent it

from rusting.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerplus POW63655 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Powerplus POW63655

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info