POWAIR0110 EN
Copyright © 2018 VARO P a g e | 4 www.varo.com
5 INSTRUCTIONS FOR OPERATION
5.1 Preparation
1. After unpacking the product, inspect carefully for any damage that may have
occurred during transit. Make sure to tighten fittings, bolts, etc., before putting unit
into service.
2. Thoroughly mix and thin paint in accordance with the paint manufacturer’s instructions.
Most materials will spray readily if thinned properly.
3. Strain material through filter, cheese cloth or a paint strainer.
4. Fill the canister about ¾ full and start the air compressor.
WARNING DO NOT EXCEED Maximum Pressure of Spray Gun or any other
parts in the compressor system.
5. After Connect the gun to air supply, please make sure that the fluid cap, container and
air hose have been connected tightly with spray gun.
6. Set up a piece of cardboard or other scrap material to use as a target and adjust for
best spray pattern.
WARNING Never aim or spray at yourself or anybody else which would
cause serious injury.
7. Test the consistency of the material by making a few strokes on a cardboard target.
THIN WITH CARE! Do not exceed paint manufacturer’s thinning recommendations.
5.2 Adjustment
The desired pattern, volume of fluid output and fine atomization can easily be obtained by
regulating the Pattern Adjusting Knob,Fluid (PAINT) Adjusting Knob.
Fig 1: 1=Increase
5.2.1 Pattern adjustment:
Turning pattern adjusting knob to the right till the end will make spray pattern round, or
turning left will make spray pattern ellipse.
5.2.2 Fluid (paint) adjustment:
Turning the paint adjusting knob clockwise will decrease the volume of fluid output and
counter-clockwise will increase fluid output.
5.2.3 Operation (Fig. 2)
▪ Suggested air pressure is 0. 2-0 3Mpa.
▪ Recommended paint viscosity differs according to paint property and painting
conditions.16 to 20 sec.
