POWE30010 EN
Copyright © 2018 VARO P a g e | 5 www.varo.com
▪ Saw blades must be kept sharp and in good condition. Replace partially fractured and
broken saw blades immediately.
▪ Work calmly and evenly with the jig saw. You will thus avoid accidents and the saw blades
and the jig saw will last longer.
7 OPERATING INSTRUCTIONS
7.1 Changing the saw blade (Fig. 1)
▪ Disconnect the saw from the mains.
▪ Loose the saw blade clamping screws (10) through the slot on the inspection guard (4) by
the aid of hex key (8) supplied with the tool.
▪ Remove the blade (5) from the holder, insert a replacement and retighten the screws.
▪ Pull the saw blade to check that it is correctly positioned and locked in place. Make sure
that the back of the saw blade engages in the slot of the guide roller (6).
▪ Connect the saw to the mains.
▪ Retain hex key in holder on saw to avoid losing it.
7.2 Switching ON/OFF (Fig. 2)
Connect the plug to the power supply, the power-on indicator (9) is illumed until the tool
disconnect from the power mains.
Switching ON: Press the On/Off switch.
Continuous operation: Lock the On/Off switch with the locking button.
Switching Off: Press the On/Off switch and release.
A: locking button
B: ON/Off switch
7.3 Adjusting the base (Fig. 3)
The base (7) can be adjusted 45° (left or right) in relation to the saw direction to facilitate
contour sawing. Loosen the two screws (11) under the base, adjust the plate to the desired
angle and retighten the screws.
Angle setting can be seen on scale on top of the base.
7.4 Dust extraction
The jigsaw is equipped with a dust extractor socket. You can connect your vacuum cleaner to
the socket at the rear of the jigsaw. If you require a special adapter, please contact the
manufacturer of your vacuum cleaner.
8 TECHNICAL DATA
