Make sure that the tool is switches off and the nozzle has cooled down.
Set the desired accessory onto the nozzle.
9 OPERATION
Always observe the safety instructions and applicable regulations.
Use only one hand to hold the tool Do not place your other hand over the
air vents
The machine must be switched off when it is connected to the mains.
Prior to operation:
Mount the correct accessory for the application.
Set the desired air temperature.
9.1 Switching on and off
Connect the plug to the power supply. The power-on indicator (10) is illumed until the tool
disconnect from the power mains.
To turn on the hot air gun, set its power switch (1) to “1” or “ll”.
o Switch “I” - Low temperature position (380°C maximum). Used for mild
heating applications, i.e., heat shrink tube, heat shrink bag, plastic
bending, shaping and welding, removing old paint coating.
o Switch “ll” - High temperature position (500°C maximum). Used for
intense heating applications, i.e., frozen water pipe, defrosting
refrigerator, and metal welding.
To turn off the hot air gun, set its power switch (4) to “l”. Then set the power switch to “0”
and unplug the tool from its electrical outlet. (This method helps cool down the heat
element properly to extend the life of the hot air gun.)
9.2 Stripping paint
Mount an appropriate accessory.
Set a high air temperature.
Switch the tool on.
Direct the hot air onto the paint to be removed.
