POWP1030 EN
Copyright © 2018 VARO p a g e | 7 www.varo.com
Important! Only ever press the spindle lock when the motor and grinding
spindle are at a standstill!
You must keep the spindle lock pressed while you change the wheel !
For grinding wheels up to approx. 3 mm thick, screw on the flange nut with the flat side facing
the grinding wheel.
7.4 Switching on / off (Fig. 6)
Before working with the angle grinder, check that the voltage shown on the
machine’s model plate is the same as the mains voltage being used.
Before engage the ON/OFF switch trigger, check that the grinding disc is
properly fitted and run smoothly, the outer flange is well tightened.
7.4.1 Switching on
1. Insert the plug into a correctly installed mains socket.
2. Push forward the ON / OFF switch with safety button (5) (See the arrow (1) on Fig. 6), and
at the same time depress it firmly inwards and keep it pressed (See the arrow (2)).
7.4.2 Switching off
▪ When you release the switch, the tool turns off.
▪ Do not let go of grinder until it has stopped running.
The wheel continues to rotate after the tool is switched off.
8 OPERATON MODES
8.1 Grinding
Hold the handle (4) and auxiliary handle (7)
firmly and switch on. Avoid blocking the
ventilation slots with your hand, as this may
cause the grinder to overheat. Let the disc reach
full speed. Apply the grinder to the item.
Maximum effect is achieved when the grinder is
held at an angle of 15-30°in relation to the item.
Move the grinder gently along the item. Give the
grinder time to work. It is rarely necessary to
press the disc hard against the surface to be worked. Sparks can occur in the motor
compartment during use. This is normal and does not mean the grinder is defective. Switch off
the grinder after use.
