POWP5020 EN
Copyright © 2020 VARO P a g e | 6 www.varo.com
▪ To switch off continuous mode, press the on/off switch again.
WARNING: Never use the machine for sanding magnesium work piece.
8.2 Guide handle
This tool has a guide handle (1) on the front of this tool which should be used only with both
handles.
8.3 Using the dust bag (Fig. 4)
Use always the supplied dust bag (2) in importance of your health when you work with the
machine
8.4 Variable speed dial (Fig. 5)
With the speed controller (9) you can adjust the speed according to application. Select the
appropriate speed setting and make sure the sander does not become overloaded and stops
running. Turn the speed controller (9) steplessly to the desired setting to increase or decrease
the speed. The controller can be adjusted from 1-6. The speed rate can be changed during
operation as well.
Hint: The required speed rate for sanding a workpiece depends on the material that you are
going to process. For best performance, make some practical tests.
9 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power plug.
9.1 Cleaning
▪ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.
▪ Keep the ventilation slots free from dust and dirt.
▪ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10 TECHNICAL DETAILS
