POWX00405 EN
Copyright © 2019 VARO P a g e | 5 www.varo.com
▪ Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical
help. Liquid ejected from the battery may cause irritation or burns.
▪ Do not open the battery yourself. There is danger of a short circuit.
▪ Protect the battery against heat, e.g., including against continuous sun irradiation and fire.
There is a danger of explosion.
▪ Do not short-circuit the battery. There is a danger of explosion.
▪ In case of damage and improper use of the battery, vapours may be emitted. In case of
complaints, provide for fresh air and consult a physician. The vapours can irritate the
respiratory system.
7 OPERATION
7.1 Charging procedure
▪ The battery charger supplied matches to the battery installed in the machine. Do not use
other battery chargers.
▪ The Li-ion battery is protected against deep discharging. When the battery is empty, the
machine is switched off by means of a protective circuit: The bit holder no longer moves.
If the On/Off switch is subject to continued use, the battery can be
damaged.
▪ The charging process starts as soon as the mains plug of the battery charger is inserted in
the socket and the machine is then connected to the battery charger.
▪ The battery charge indicator lights up red to indicate the charging procedure. The battery
is fully charged when the red indicator light goes out.
During the charging procedure, the handle of the machine warms up. This
is normal.
When the charging is finished, disconnect the battery charger from the
socket.
Do not use the machine during the charging procedure.
7.2 Inserting and extracting bits
Important! Always turn off the switch before you change the screw bit to avoid unintentional
starting of the machine. When the machine is completely stopped, insert or extract the screw
bit.
Only use tool bits which can be securely fastened in the chuck and for
which the bits has been designed.
Before using the machine check whether the screw-bit is inserted correctly.
Avoid over-tightening screws, otherwise the screw head may be damaged
or stripping of the threads may occur.
7.3 On/Off trigger
Use the On/Off trigger to start the machine and keep holding it for continuous operation.
To switch the machine off, release the On/Off trigger.
