644888
8
Zoom out
Zoom in
Vorherige Seite
1/12
Nächste Seite
POWX0054LI EN
Copyright © 2016 VARO P a g e | 8 www.varo.com
9 (PRE)OPERATION
9.1 Battery charging
Use only the battery charger supplied with your tool. Only these battery chargers are matched
to the lithium ion battery of your power tool.
Note: The battery is supplied partially charged. To ensure full capacity of
the battery, completely charge the battery in the battery charger before
using your power tool for the first time. The lithium ion battery can be
charged at any time without reducing its service life. Interrupting the
charging procedure does not damage the battery.
Charging procedure 1h:
Adapt the charger to the mains. The green led will light up, the red led remains unlit.
Place the battery in the charger. The green led will go out, the red led will light up.
When the battery is fully charged (after 1 hour), the green led and the red led will both
light up.
The battery indicator leds on the tool (yellow, green red), will show the battery status
when pressing the on/off trigger (5). When only the red led is lit, the battery needs
recharging.
9.2 To install or remove the battery pack
9.2.1 To remove the battery
Depress both the battery release buttons and gently pull the battery out of the drill.
9.2.2 To install the battery
Hold the drill upright in one hand and the battery in your other hand. While pressing with two
fingers on the battery release buttons, insert the battery until it clicks into place. Do not use
excessive force when inserting the battery. If the battery does not slide in easily, it is not being
inserted correctly. It is also possible that there could be damage to the battery, battery
terminals or the drill.
9.3 Installing/removing bits and drills
9.3.1 Installing bits/drills
Lock the switch trigger by placing the direction of rotation selector in centre position.
Open or close chuck jaws to a point where the opening is slightly larger than the bit size you
intend to use. Also, raise the front of the drill slightly to keep the bit from falling out of the
chuck jaws. Insert drill bit straight into chuck the full length of the jaws as shown in. Tighten
the chuck jaws on the drill bit.
WARNING: Make sure to insert drill bit straight into chuck jaws.
Do not insert drill bit into chuck jaws at an angle, this could cause drill bit to be thrown from
drill resulting in possible serious personal injury or damage to the chuck.
9.3.2 Removing bits/drills
Lock the switch trigger by placing rotation selector in centre position.
Loosen the chuck jaws from the drill bit.
Note: Rotate chuck body in the direction of the arrow marked. Release to loosen chuck jaws.
Do not use a wrench to tighten or loosen the chuck jaws.
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Powerplus POWX0054LI wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Powerplus POWX0054LI

Powerplus POWX0054LI Bedienungsanleitung - Deutsch - 13 seiten

Powerplus POWX0054LI Bedienungsanleitung - Holländisch - 13 seiten

Powerplus POWX0054LI Bedienungsanleitung - Französisch - 13 seiten

Powerplus POWX0054LI Zusatzinformation - Alle Sprachen - 1 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info