POWX11831 EN
Copyright © 2020 VARO NV P a g e | 6 www.varo.com
▪ Place the collar onto the collar mount and then let the two holes of collar at the both ends
of the clamping block.
▪ Adjust the handle subassembly to a desire position, finally securely tighten the handle.
▪ Remove the auxiliary handle subassembly in the opposite way.
8.2.2 Side handle
The auxiliary handle can be attached in two different mounting holes: left and right.
Remove the auxiliary handle subassembly in the opposite way.
8.3 Use (Fig. 4
▪ After placing the tip of the tool on concrete surface, switch the tool ON.
▪ By utilizing the weight of the machine and by firmly holding the demolition hammer with
both hands, you can control the subsequent recoil motion.
After long time of use, the cylinder case becomes hot. Therefore, be careful
not to burn your hands.
Don’t apply big pressure on the machine. The hammer mechanism is
activated by applying a slight pressure on the tool when the chisel bit is in
contact with the work-piece.
It is possible that some oil between drill and cylinder box could spray when
you’re ooperating the tool. Therefore, when you want to use the tool inside
a room, it’s recommended to use old newspapers or towels to cover the
floor and wall.
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning
▪ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.
▪ Keep the ventilation slots free from dust and dirt.
▪ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10 TECHNICAL DATA
