675262
7
Zoom out
Zoom in
Vorherige Seite
1/15
Nächste Seite
POWX510 EN
Copyright © 2015 VARO P a g e | 7 www.varo.com
8.4 Assembly wheels
Slide every wheel over an axle. Put a cotter pin in the bore of every wheel axle and bend the
ends of the cotter pin to fix.
9 CONTROL FUNCTIONS
9.1 Recoil starter
To start the engine, pull the starter grip lightly until resistance is felt, then pull briskly.
Do not allow the starter grip to snap back against the engine. Return it
gently to prevent damage to the starter. When starting the engine by recoil
starter, set the key switch at the ON position and pull the starter handle.
9.2 Fuel valve lever
The fuel valve is located between the fuel tank and carburetor. When the valve lever is in the
ON position, fuel is allowed to flow from the fuel tank to the carburetor. Be sure to return the
fuel valve lever to the OFF position after stopping the engine.
9.3 Choke rod
The choke is used to provide an enriched fuel mixture when starting a cold engine. It can be
opened and closed by operating the choke rod manually. Pull the rod out toward CLOSED to
enrich the mixture for cold starting.
9.4 Ground terminal
The generator ground terminal is connected to the frame of the generator, the metal non-
current-carrying parts of the generator and the ground terminals of each receptacle
9.5 DC circuit breaker
The DC circuit protector automatically shuts off the DC battery charging circuit when the DC
charging circuit is overloaded, when there is a problem with the battery or when the
connections between the battery and the generator are improper.
9.6 Oil alert system
The oil alert system is designed to prevent engine damage caused by an insufficient amount
of oil in the crankcase. Before the oil level in the crankcase can fall below a safe limit, the oil
alert system will automatically stop the engine (the engine switch will remain in the ON
position). The oil alert system should not take the place of checking the oil level before each
use.
If the engine stops and will not restart, check the engine oil level before troubleshooting in
other areas.
9.7 AC circuit breaker
The AC circuit breaker will automatically switch OFF if there is a short circuit or a significant
overload of the generator at the receptacle. If the AC circuit breaker is switched OFF
automatically, check that the appliance is working properly and does not exceed the rated laod
capacity of the circuit before switching the AC circuit breaker ON again. The AC circuit breaker
may be used to switch the generator power ON or OFF.
10 PRE-OPERATION CHECK
10.1 Engine oil
Engine oil is a major factor affecting engine performance and service life.
Non-detergent and 2-stroke engine oils will damage the engine and are not
recommended.
7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Powerplus POWX510 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Powerplus POWX510

Powerplus POWX510 Bedienungsanleitung - Deutsch - 17 seiten

Powerplus POWX510 Bedienungsanleitung - Holländisch - 17 seiten

Powerplus POWX510 Bedienungsanleitung - Französisch - 17 seiten

Powerplus POWX510 Zusatzinformation - Alle Sprachen - 4 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info