POWXB20030 EN
Copyright © 2021 VARO P a g e | 8 www.varo.com
1. Frequently monitor the charger and battery pack while connected.
2. Unplug the charger and disconnect it from the battery pack when finished.
3. Allow the battery pack to cool completely before using it.
4. Store the charger and battery pack indoors, out of reach of children.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down
to room temperature before charging. This will extend the life of your
batteries.
9.2 Removal / insertion of battery (Fig. 2)
WARNING: Before making any adjustments ensure the machine is switched
off or remove the battery pack.
▪ Hold the tool with one hand and the battery pack (10) with the other.
▪ To install: push and slide battery pack into battery port, make sure the release latch on the
rear side of the battery snaps into place and battery is secure before beginning operation.
▪ To remove: Press the battery release latch and pull the battery pack out at the same time.
9.3 Battery capacity indicator (Fig. 3)
There are battery capacity indicators on the battery pack, you can check the capacity status of
the battery if you squeeze the button (12). Before using the machine, please press switch
trigger to check if the battery is full enough for properly working.
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are lit: Battery fully charged.
2 LED’s are lit: Battery 60% charged.
1 LED is lit: Battery almost discharged.
10 ASSEMBLY
10.1 Fitting the auxiliary handle (Fig. 4)
Warning: Prior to assembly and adjustment always switch off the grinder
and pull out the battery pack from the angle grinder body.
The auxiliary handle (6) can be attached to the angle grinder in 2 different positions: left and
right.
10.2 Assembly of the protective guard (Fig. 5-6)
▪ Place the protective guard (7) on the front gear housing.
▪ Adjust the position of the protection guard to the requirements of the operation.
▪ Lock the protection guard tightening the locking screw with a hex key or screw driver.
▪ Check if the protective guard has been fixed firmly and correctly.
Note: the protective guard must be positioned to protect the user if the disc
shatters during use.
10.3 Replacing the grinding disc (Fig. 7 – 8)
Beware – a disc which has been used may be very hot!
