Bedienungsanleitung Powerplus POWXG7540 (Seite 8 von 11) (Englisch)

582105

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

POWXG7540 EN

8.4.2 Working without grass bag

If using the scarifier withtout bag:

 Pull the fixing pole and lift the ejection gurad, then release the fixing pole. (Fig. 7)

 The ejection guard will flip back and open an angle. (Fig. 8)

8.5 Tips for proper working

It is recommended that you overlap scarifying paths a little. Try to scarify in straight lines for a

nice, clean look. Insodoing, the aeration swaths should always overlap each other by a few

centimeters in order to avoid bare strips.

As soon as grass clippings start to trail the scarifier, it is time to empty the grass basket.

Important! Before taking off the grass basket, switch off the motor and wait until the roller has

come to a stop.

To remove the grass basket, lift up the ejector flap with one hand, while unhooking the basket

with the other.

How frequently you should scarify your lawn is determined primarily by the speed at which the

grass grows and the hardness of the soil.

Keep the underside of the equipment clean and remove soil and grass build-up. Deposits

make it more difficult to start the aerator and decrease the quality of the scarifying.

Always scarify along inclines (not up and down).

Switch off the motor before doing any checks on the roller.

Important! The roller rotates for a few seconds after the motor is switched off. Never attempt to

stop the roller.

In the event that the rotating roller strikes an object, immediately switch off the equipment and

wait for the roller to come to a complete stop. Then inspect the condition of the roller. Replace

any parts that are damaged.

9 CLEANING AND MAINTENANCE

9.1 Scarifier Maintenance

The scarifier should be cleaned thoroughly every time after it has been used. This particularly

applies to its underside and the blades. To do so tip the scarifier slightly on to its side and

remove the dirt.

Important! Before you tip the equipment, the petrol tank must be emptied to

prevent petrol leaking out. Ideally you should use a conventional petrol

extraction pump for this purpose.

9.2 Engine Maintenance

Please follow engine manual to maintain the engine.

9.2.1 Spark Plug

After every 50 hours of running the spark plug should be removed. Check the color of the

deposits on the end of the spark plug it should be a “Tan” color. Remove all deposits using a

stiff brush a brass wire brush is ideal. Check the spark plug gap and adjust if required. The

correct gap should be 0.7 to 0.8mm.

9.2.2 Engine Oil Replacement

 We recommend that the oil be changed after the first 40 hours of use, then once every

100 hours.

 Place the machine on a level surface and warm up the engine for several minutes. Then

stop the engine.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerplus POWXG7540 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Powerplus POWXG7540

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info