Bedienungsanleitung Powerplus POWXG9008 (Seite 11 von 13) (Englisch)

582181

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

POWXG9008 EN

14.2 Clearing a blockage (Fig. 17)

Before checking, adjustments, cleaning or maintaining the pressure

washer, the engine must be stopped and cooled down. Ensure, that the

pressure is released completely

If at any time the flow rate reduces splutters or is inconsistent release the trigger and switch

“OFF” the machine. Squeeze the trigger to relieve any pressure and check the jet in the end of

the lance for any blockage. If a blockage is suspected use the jet cleaning tool to remove any

blockage. It is important that the water jet is checked and cleaned regularly using the jet

cleaning tool supplied. Turn the engine off and disconnect from the water supply before

clearing a blockage

14.3 Routine maintenance

14.3.1 Spark plug

After every 100 hours of running the spark plug should be removed. Check the colour of the

deposits on the end of the spark plug it should be a “Tan” colour. Remove all deposits using a

stiff brush a brass wire brush is ideal. Check the spark plug gap and adjust if required. The

correct gap should be 0.7 to 0.8mm.

14.3.2 Engine oil replacement (Fig. 19)

We recommend that the oil be changed after the first 20 hours of use, then once every 100

hours.

 Place the machine on a level surface and warm up the engine for several minutes.

 Then stop the engine.

 Place a suitable container below the pump to catch the used oil.

 Remove the oil fill cap, oil drain plug and the washer so that the oil can be completely

drained. You will need to use a tube or other similar device to prevent the oil leaking onto

the frame of the pressure washer.

 Check the oil drain plug, gasket, oil filler cap and O-ring and if damaged replace.

 Reinstall the oil drain plug and the washer. Tighten the drain plug securely.

 Add engine oil to at least half of the dipstick.

 Reinstall the oil fill cap securely

Please dispose of used motor oil in a manner that is compatible with the environment. We

suggest you take it in a sealed container to your local service station for reclamation. Do not

throw it in the trash or pour it on the ground.

14.3.3 Air filter

After every 50 hours of running or every year, the air filter should be removed, examined for

deterioration and cleaned. Clean the air filter thoroughly using environmentally friendly water

based degreasing agent. Allow to dry fully then replace the air filter.

Warning! Never run the engine without the air filter fitted

14.3.4 Fuel tank filter (Fig. 18)

After every 150 hours of running or every three months the fuel tank filter should be removed

and cleaned. Remove the fuel tank filler cap and the filter, clean the filter thoroughly using

environmentally friendly water based degreasing agent and re-fit

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Powerplus POWXG9008 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Powerplus POWXG9008

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info