721989
30
Zoom out
Zoom in
Vorherige Seite
1/34
Nächste Seite
30
Rally
Always disassemble or assemble your scooter on a level, dry surface with sufficient room for you to work
and move around your scooter. Keep in mind that the disassembled sections of the scooter take up more
floor space than the assembled scooter.
VIII. DISASSEMBLY AND ASSEMBLY
DISASSEMBLY
1. Remove the key from the key switch. See IV. Your Rally.
2. Pull up on the manual freewheel lever. See IV. Your Rally. Putting your Rally in freewheel mode
makes it easier for you to maneuver the rear section because the drive wheels are free to turn.
3. Lift the seat up and off of your scooter.
4. Gently lift the rear shroud off of your scooter. The rear shroud is held in place with a reusable fastener.
5. Unplug both battery harness connectors. See figure 15.
6. Remove the battery straps and lift both batteries from the battery wells.
7. Unplug the large, white, 9-pin front-to-rear connector that connects the front control console assembly
harness to the electronic controller assembly harness. See figure 15.
CAUTION! Failing to unplug both battery harness connectors and the front-to-rear connector prior
to further disassembly could result in permanent damage to your scooter.
WARNING! Lifting weight beyond your physical capability may result in personal injury. Ask for
assistance when necessary while disassembling your scooter.
FIGURE 16. FRONT-TO-REAR LOCKING LEVER
Separating The Front And Rear Sections
1. Lower the scooters tiller to the centre of the floorboard by turning the tiller adjustment lever anticlockwise
until it is loose. Press the tiller release buttons and lower the tiller to the centre of the floorboard.
Tighten the tiller adjustment lever.
2. Pull up on the front-to-rear locking lever (releases the locking pin) with one hand, and push on the seat
pedestal to pivot the scooters rear section rearward with your other handfar enough so the rear
sections upper pegs come free of the front sections upper slots. See figures 16 and 17.
3. With one hand on the seat pedestal and one hand on the frame handle, slightly lift the front section and
slide the front and rear sections apart. See figures 17 and 18.
FRONT-TO-REAR CONNECTOR
FIGURE 15. BATTERY HARNESS CONNECTORS/
FRONT-TO-REAR CONNECTOR
BATTERY HARNESS CONNECTORS
FRONT-TO-REAR LOCKING LEVER
LOCKING PIN
30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Pride Rally XL wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Pride Rally XL

Pride Rally XL Bedienungsanleitung - Deutsch - 26 seiten

Pride Rally XL Bedienungsanleitung - Holländisch - 20 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info