4
SETTINGS:
-Off
- Massage
- Heat with massage
IMPORTANT INSTRUCTIONS:
- Remove the plug from the outlet when the bath is being filled, emptied or cleaned.
- Do not stand in the bath.
- Do not use the bath longer than 20 minutes at one time. After 20 minutes, the bath must be switched
off so it can cool off to room temperature.
- You can use a little bit of bath oil in the bath. Do not use any other products in the water. Use only
clean tap water.
- If you have diabetes, first consult your doctor before using the bath.
- If you have any wounds or other health problems with your feet or legs, or if you experience pain,
itching or a burning feeling after using this bath, consult your doctor first before using the bath again.
- Do not fill the bath higher than the MAX line.
- Place the bath on a stable, level floor, but not on thick carpeting or a thick rug, as this could block the
ventilation openings.
INSTRUCTIONS FOR USE:
- Use a jug, small pail or suchlike to fill the bath with warm or cold water, whichever you prefer.
The bath has sufficient heat to maintain the temperature of warm water for a maximum period of
20 minutes, but not to warm up cold water. So if you want a warm foot bath, the water should be
poured into the bath at the desired temperature.
- Place a chair in front of the bath, plug in the appliance and switch it to the desired setting.
- First sit and then place your feet in the bath. Do not stand in the bath!
- Make sure that the water does not splash over the edge of the bath or on the selector switch.
- After use, set the selector switch on stop and remove the plug from the outlet.
- Clean the bath with clean water and mild cleaner, then dry off. Do not use any abrasive cleaners or
sponges.
SAFETY:
- Do not wind the cord tightly around the bath.
- Do not use the foot bath in the bathroom or shower, or near a sink(s) filled with water.
- Operate the bath with dry hands.
- Only allow the bath to be used by persons who can read and understand these instructions.
- Do not use the bath if it is damaged or if the cord is damaged. In that case, bring the bath back for
repair. A damaged cord can only be replaced with the special tools of the technical service department.
- This foot bath is intended for household use only.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
As the colours of the wire in the mains lead of this appliance may not correspond with the colour
markings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with
the letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked
with the letter L or coloured red.
WARNING: ON NO ACCOUNT SHOULD EITHER THE LIVE OR
NEUTRAL WIRES BE CONNECTED TO THE EARTH TERMINAL
