7
PULSE 2 Jack
These instructions are to be used with a treadmill that has a
TV and resembles the treadmill shown in the drawings at the
right.
1. Make sure that the power cord is unplugged. Remove
the indicated Screws from the Console Back (A).
Important: The Screws may be different lengths. Keep
track of which Screws were removed from which holes.
2. Raise the Console (C) enough to view the back of the
Console. Peel the paper off the pad on the bottom of the
Receiver (B). Turn the Receiver so the cylinder is on
the side shown, and press the Receiver onto the back of
the Console in the indicated location.
3. Connect the included Short Jumper Wire (D) to the wire
on the Receiver (B). Connect the other end of the Short
Jumper Wire to the PULSE 2 jack on the back of the
Console (C). If there is a wire already plugged into the
PULSE 2 jack, unplug it. Note: The other wires included
with the receiver may be discarded. The Wire Tie can be
used to tie wires, if needed.
Make sure that no wires are pinched. See step 1.
Reattach the Console (C) with the Screws. Important: If
the Screws are not put back into the same holes from
which they were removed, the Console will be dam-
aged.
Screws
A
C
1
