572632
4
Zoom out
Zoom in
Vorherige Seite
1/8
Nächste Seite
6
7
The device was designed for extensive usage. To ensure longevity and
performance, please adhere to the following:
GUIDELINES FOR OPERATION
INSTALLATION OF BATTERIES
EXTERNAL POWER SUPPLY
Before use make sure that you have installed the digital module
according to the instructions of the section 8.
Store with the lens cap on in the carrying case.
Switch off the unit after use.
The unit cannot be submerged in water.
Attempts to disassemble or repair the unit will void the warranty!
Clean the device's optical surfaces only if necessary, and use caution.
First, remove (by blowing with a blower brush or canned air) any dust or
sand particles. Then proceed to clean by using camera/lens cleaning
equipment approved for use with multicoated lenses. Do not pour the
solution directly onto the lens!
The device can be used in operating temperatures ranging from
-25 °C... +50 °C. However, if it has been brought indoors from cold
temperatures, do not turn it on for 3 to 4 hours. This will prevent external
optical surfaces from fogging.
To ensure reliable performance, it is recommended to carry out regular
technical inspections of the unit.
Batteries shall not be exposed to excessive heat such as sunshine, fire or
the like.
Turn the lever (8) of the battery container (11) 90 degrees in “Open”
position and, pulling by the lug of the cover, remove the battery container.
Install four AA batteries (or rechargeable batteries) observing marking
shown on the battery container.
Insert the battery container into the battery compartment observing
polarity and turn the l ever 90 degrees clockwise .
Note: to ensure long and reliable operation it is recommended that you use
quality rechargeable batteries with a capacity of at least 2500 mAh. Please
do not use batteries of different types or batteries with various charge
levels.
The device can be powered with an external DC power supply
(2.1mm pin) with stabilised voltage ranging from 8.4V to 15V
or a 12V vehicle socket.
External power supply (AC/DC) is to be connected to “Power” (9) jack
located on the right side of the device.
Please note that the central pin of the power supply that you
connect to the “power” jack of the unit, must have marking
“+”. The power supply may have marking .
Connection of an external power supply (icon shows up on the data
panel) automatically cuts off power supply from batteries.
External power supply DOES NOT charge the rechargeable batteries
in the unit.
Attention! We suggest that you use battery packs EPS3 or EPS5
ensuring from 7 to 18 hours of operation.
PWR
10
17
24
25
MOUNTING THE MONOCULAR ON DIGITAL MODULE
The monocular Pulsar 10x32 (included) converts the digital module into a
digital night vision device with 10x magnification.
Insert the monocular firmly so that the pins (24) in the monocular’s body
enter the notches (17) of the digital module and the groove (25) coincides
with the lock (10) (see pic.).
Turn the monocular counterclockwise so that the lock (10) snaps.
In order to remove the monocular, move the lock (10) sideways and turn
the monocular clockwise until it clicks.
Pull the pins (24) out of the monocular’s notches (17) and remove the
monocular c arefully.
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

pulsar-forward-dn55

Suche zurücksetzen

  • Beim einjustieren der Horizontale verschiebt sie sich nach kurzer Zeit wieder (Fadenkreuz) Eingereicht am 18-2-2020 15:52

    Antworten Frage melden
  • mit aufgesetztem gerät schießt die waffe 30cm zu tief .wie kannn ich das ändern ? Eingereicht am 4-1-2018 09:51

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Pulsar Forward DN55 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info