Error codes
It is possible that failures occur. If this happens, go to
the dealer as soon as possible so repairs can be carried
out quickly. The following codes can be displayed on
the display:
Error 1: Problem with 3-phase control from the
controller
Error 2: Problem with throle connecon (start-
detecon)
Error 3: Motorcable 3-phase wiring loose or defecve
Error 4: Motorcable Hall Sensor signal malfuncon
(malfuncon in motor or motorcable)
Error 5: Malfuncon in brake sensor(signal)
Error 6: Baery voltage too low
Error 7: Motor stalled
Error 8: Malfuncon in controller (signal)
Error 9: Malfuncon in display (signal)
SET 2: Seng the speedlimiter
Please note: Opon only availible on P-RD9(s)
With the ‘PLUS’ and ‘MINUS’ you can adjust the
speedlimiter. With this you can limit the maximum
speed in which the motor provides power. This can be
handy if you prefer to drive on lower speeds.
SET 3: Seng the Tire-size
Set the correct re-size for more exact informaon on
the screen. On the side of every re you can nd the
size. The pre-set sizes may deviate a lile. This means
that the amount of driven kilometers has a maximum
deviaon of 5%.
The default seng for your QWIC bike is:
28 inch 40-622 Circumference: 2205 mm*
SET 4: (Speed) Units
With the ‘PLUS’ and ‘MINUS’ buons you can switch
between kilometers (per hour) and miles (per hour).
SET 6: Baery informaon
Please note: Opon only availible on P-MN7 / P-MN360
With the ‘PLUS’ and ‘MINUS’ buons you can see the
following informaon of the baery: The percentage of
the remaining battery-capacity, the total charging-cycli
and the actual battery voltage.
