490218
5
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
5
INSTALLATION CONSIDERATIONS
GENERAL SUGGESTIONS
a Make sure you have enough high quality speaker wire at hand, to reach all
the drivers and crossovers from their intended mounting locations! The
preferable cross-section is 2 x 2.5mm
2
. Please note that for quality reasons,
some of the speaker wiring must be purchased separately.
s Before you attempt to mount the tweeter(s) or mid/woofer(s) to the doors of
your vehicle, check the available mounting depth! Always make sure the
speakers or crossovers do not impair with the door or window functions.
d Before you start any wiring work, speaker mounting etc, disconnect the
negative main wire lead from the battery! For your own safety…
f Never run speaker wires over or through sharp edges. Use rubber
grommets to protect wires routed through sheet metal.
MOUNTING LOCATION
A solid front stage with good stereo imaging is the most difficult task to
achieve in a vehicle! Mostly because the speakers are placed where they will fit
easily, as opposed where they can perform best. In most cases, the factory
cutouts – i.e. in the front doors of a vehicle – offer a stable and convenient
mounting platform for the mid/woofers. In some cases you will need to pur-
chase car specific plastic adaptors that enable mounting Euro-DIN style
mid/woofers to the factory speaker cutouts.
The mounting location for the tweeters does have a profound and direct effect
on the stereo imaging of your component system install. Therefore, after
mounting the mid/woofers and crossovers – it is recommended to provisionally
fix the tweeters to different locations, to be able to choose the mounting spot
that offers best possible imaging.
Some mounting tips:
a Place the tweeters where they have a direct and unobstructed path to the
listening area. The best visual location may not be the best sounding one!
s Listen to the system with both tweeters connected to the crossovers in
phase (
to , to ) AND reversed, before setting tweeter level
attenuation.
d Be sure to use the supplied foam gaskets when mounting the mid/woofers.
These gaskets enable an airtight seal between the mid/woofer mounting rim
and the speaker mounting hole, which is important to obtain the maximum
dynamic range in the upper bass range!
f The installation of your component set is carried out best, following the
sequence below: Removal of Factory Speakers
z Wire Routing z
Installation of the Mid/Woofers z Mounting of the Crossovers z Mounting
of the Tweeters
RA13.2-16.2 Manual 12.03.2004 19:14 Uhr Seite 5
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Radical Audio RA16.2RF wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info