500582
1
Zoom out
Zoom in
Vorherige Seite
1/6
Nächste Seite
1
STARTING THE DEVICE:
Press the button 5 on the side of the Turbo to turn the
device on (Turbo + towel dryer).
Indicators 2 and 3: Steady green - Turbo + Towel dryer
turned on
Filter indicator 1: Off
Indicator 3: Steady red - towel dryer running
BLOWER 2 OPERATING LIGHT:
Off: Power Off
Steady green: Power On
Blinking red: Operating
TURBO 1000 WATT
The Turbo is designed to quickly raise the temperature in your bathroom.
Install the timer in the same room as the towel dryer. The
timer must be installed about 1.5 metres above the floor,
on an inside wall, away from splashing water, direct
sunlight and direct source of direct thermal disturbance.
Note: To ensure proper infrared transmission:
- Do not obstruct transmitter and receiver cells
(bath towels in front of the cell).
- Avoid using electronic ballast lighting in the same room.
Set the dial for the desired time and press the “OK / Boost”
button to start the blower.
NOTE: Forced operation of the device can be interrupted at
any time by pressing the “OK / Boost button again. When
restarting the blower in this case, the remaining Boost time
will be the setting shown on the dial.
Infrared receiver on Turbo
UK
1. Filter cleaning indicator
2. Blower operation indicator
3. Towel dryer operation indicator
4. Infrared receiver cell
5. Start/towel dry button
SPECIFIC CASES
Overheating
If towels or any other obstructions block the Turbo outlet
excessively, causing overheating, the device will shut down
(indicators 2 and 3 blinking red / green). The Turbo operation
will restart once the temperature cools, for the remaining
preset length of time.
Thermal safety:
If the Turbo resistor overheats a manually reset thermal
safety device mechanically stops blower operation.
Indicator light status:
Filter indicator 1: Blinking red and
Blower indicator 2: Steady green
Important: A dirty filter can cause overheating. Clean it if
necessary. Press button 5 “start/stop” for 5 seconds to stop
this alarm.
Note: Please clean the filter each time the Clean Filter alarm
is triggered (“see Cleaning the Filter”).
Caution: if the cause of overheating has not been identified
the alarm will be triggered again. In this case, please contact
the installer since this may cause the Turbo to deteriorate
over time.
The infrared timer trans-
mitter lets you send a start
command to the Turbo for
a variable period of 0 to 2
hours.
TIMER ON HOT WATER VERSION DEVICES
21 43 5
1

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Radson Turbo wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info