20
Inspect and properly tighten all parts of the exercise
cycle regularly. The exercise cycle can be cleaned
with a soft, damp cloth. To prevent damage to the
console, keep liquids away from the console and keep
the console out of direct sunlight.
TIGHTENING THE PEDALS
For best performance, regularly tighten both pedals.
CONSOLE TROUBLESHOOTING
If the console displays flicker or darken, increase your
pedaling pace. If the console does not display your
heart rate when you use the handgrip pulse sensor,
refer to step 5 on page 11.
HOW TO LEVEL THE EXERCISE CYCLE
If the exercise
cycle does not sit
flat on the floor,
turn one or both
of the leveling
pads until the
exercise cycle is
level.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is at the highest level, the
Drive Belt (not shown) may need to be adjusted. To
adjust the Drive Belt, the Right Side Shield (5) must
first be removed. Remove the indicated M4 x 38mm
Screws (30) and M4 x 16mm Screws (21) from the
Right Side Shield. Using an adjustable wrench, turn
the Right Pedal (37) counterclockwise and remove it.
Next, turn the Right Crank Arm (27) so that it is point-
ing toward the front of the exercise cycle, and then
slide off the Right Side Shield.
Next, turn the
indicated M8
Nylon Locknut
(56) until the
Drive Belt (69)
is properly
tightened.
Then, reattach
the right side
shield and the
right pedal.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. Refer to HOW TO
ADJUST THE DRIVE BELT at the left. Remove the
indicated M4 x 38mm Screws (30) from the Right Side
Shield (5) and the M4 x 16mm Screws (not shown)
from the Left Side Shield (4). Using an adjustable
wrench, turn the Left Pedal (not shown) clockwise and
remove it. Turn the Left Crank Arm (34) so that it is
pointing toward the front of the exercise cycle, and
then slide off the Left Side Shield.
Locate the
Reed Switch
(44). Turn the
Left Crank
Arm (34) until
the Magnet
(75) is aligned
with the Reed
Switch.
Loosen, but
do not
remove, the
indicated M4 x
16mm Screw
(21). Slide the
Reed Switch slightly closer to or away from the
Magnet. Then, retighten the Screw. Turn the Left
Crank Arm for a moment. Repeat until the console
displays correct feedback. When the Reed Switch is
correctly adjusted, reattach the left side shield and the
left pedal.
MAINTENANCE AND TROUBLESHOOTING
Leveling
Pads
30
21
5
4
37
56
34
69
27
44
21
75
