Bedienungsanleitung Reloop CONTOUR Interface Edition (Seite 23 von 64) (Deutsch, Englisch, Französisch)

490508

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite





the device is prohibited. Please note that in the event of damage caused by the manual modica-

tion to this device any warrantyclaims are excluded.

- The inside of the device does not contain any parts which require maintenance, with the excep-

tion of wear parts that can be exchanged from the outside. Only qualied staff must carry out

maintenance, otherwise warranty does not apply!

- The Fuse must exclusively be exchanged against fuses of the same class, with the same trigger

features and nominal current rating.

- Make sure that the power will only be supplied after the device has been fully set up. Always plug

in the mains plug last. Ensure that the mains switch is in the “OFF” position when connecting the

device to power.

- Only use cables that comply with regulations. Observe that all jacks and bushes are tightened

and correctly hooked up. Refer to your dealer if you have any questions.

- Ensure that when setting up the product the mains cable is not squashed or damaged by sharp

edges.

- Prevent the mains cable from coming into contact with other cables! Exercise great care when

handling mains cables and connections. Never touch these parts with wet hands!

- Connect the power cable exclusively to appropriate shock-proof outlets. The only supply point to

be used is a supply outlet in accordance with specications of the public supply network.

- Disconnect the device from the supply outlet when not in use and before cleaning! Be sure to

hold the mains plug by the body. Never pull the mains cord!

- Position the device on a horizontal and stable low-ame base.

- Avoid any concussions or violent impact when installing or operating the device.

- When selecting the location of installation make sure that the device is not exposed to excessive

heat, humidity, and dust. Be sure that no cables lie around openly. You will endanger your own

safety and that of others!

- Do not rest any containers lled with liquid that could easily spill onto the device or in its imme-

diate vicinity. If, however, uids should access the inside of the device, immediately disconnect

the mains plug. Have the device checked by a qualied service technician before re-use. Damage

caused by uids inside the device is excluded from the warranty.

- Do not operate the device under extremely hot (in excess of 35° C) or extremely cold (below 5°

C) conditions. Keep the device away from direct exposure to the sun and heat sources such as

radiators, ovens, etc. (even • during transport in a closed vehicle). Never cover the cooling fan or

vents. Always ensure sufcient ventilation.

- The device must not be operated after being taken from a cold environment into a warm environ-

ment. The condensation caused hereby may destroy your device. Do not switch on or operate the

device until it has reached • ambient temperature!

- Controls and switches should never be treated with spray-on cleaning agents and lubricants. This

device should only be cleaned with a damp cloth. Never use solvents or cleaning uids with a

petroleum base for cleaning.

- When relocating, the device should be transported in its original packaging.

- When starting operation, the faders and volume controls of your amplier must be set to mini-

mum level. Bring the loudspeaker switches into the “OFF” position. Wait between 8 to 10 seconds

before increasing the volume to avoid shot noise created by transient effect, which could cause

damage to loudspeakers and the diplexer.

- Devices supplied by voltage should not be left in the hands of children. Please exercise particular

care when in the presence of children.

- At commercial facilities the regulations for the prevention of accidents as stipulated by the orga-

nization of professional associations must be observed.

- At schools, training facilities, hobby and self-help workshops the operation of the device must be

monitored with responsibility by trained staff.

- Keep this operation manual in a safe place for later reference in the event of questions or prob-

lems.



- This device is a professional DJ MIDI controller with integrated 8 channel soundcard that can

control software. The device should be connected via USB cable to a computer.

- This product is authorised for connection to switching power AC 100-240V, 50/60Hz and is desig-

ned exclusively for indoor application.

- If the device is used for any other purposes than those described in the operation manual, da-

mage can be caused to the product, leading to exclusion of warranty rights. Moreover, any other

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Reloop CONTOUR Interface Edition Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info