Bedienungsanleitung Reloop CONTOUR Interface Edition (Seite 34 von 64) (Deutsch, Englisch, Französisch)

490508

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite





T16 

By turning the encoder a set loop can

be shifted.

Simultaneously pressing and tur-

ning the encoder determines the

movement‘s range.



Allows the temporary acceleration (clockwise)

or deceleration (counterclockwise) of a track.

T17 

Regulates the lter effect for the active

deck. In the zero position the lter will

be deactivated automatically.



Via the Cue Mix Fader a pre-mix can be simula-

ted in your headphones. When to the right the

master signal is audible, when to the left the

cue signal is audible.

T18 

Herewith you can adjust the volume

division for the left and right channel.

The zero position corresponds to an

equal level on both channels.



Adjusts the master volume.

T19 

Sets an automatic loop with the adjus-

ted loop length (-T15-), without having

to manually set the ending point.



Manually sets the starting point of a loop.

Simultaneously a cue point will be set.

T20 

Jumps to the last set loop and reacti-

vates it.



Manually sets the ending point of a loop.

Now the deck is in a loop mode, the selected

sequence is permanentely repeated.

Pressing the button again will end the loop

mode.

T21 

Carries out a beat jump against oppo-

sed to the playback direction.



Shifts the grid that Traktor puts over the bass

line a step to the left.

T22 

Carries out a beat jump in the playback

direction.



Shifts the grid that Traktor puts over the bass

line a step to the right.

T23 

Selects the desired hot cue bank. If

„1-4“ is pressed, the hot cue points 1-4

can be controlled in Traktor. Shortly

pressing „5-8“ facilitates the control of

hot cues 5-8 via the Hot Cue Buttons

-T24-.

T24 

Herewith it is possible to control the 8

hot cues of a track in Traktor. Depen-

ding on which bank is currently active

hot cues 1-4 and 5-8 respectively can

be controlled.

If a hot cue is not occupied (no LED

feedback), this hot cue will be assigned

to the current track position by pres-

sing one of the pads.

T25 

If this element is pressed, the current

track position is saved on a free hot

cue.

T26 

While this button is being pressed and

held the saved hot cue points can be

deleted by pressing the corresponding

hot cue pads -T24-. The LED of the

corresponding pad will go out.

Afterwards release the Delete Button in

order to leave delete mode.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Reloop CONTOUR Interface Edition Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info