Bedienungsanleitung REMKO RKL290 (Seite 7 von 16) (Englisch)

587566

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Infrared Remote Control

Inserting the batteries into the remote control

Prior to initial operation, the batteries supplied with the

unit (2 type AAA batteries) must be inserted into the re-

mote control.

1. Slide off the cover of the battery slot on the back

of the remote control.

2. Place the batteries in the slot making sure that

the polarity is correct.

Use the labelling in the slot.

3. Close the cover.

General Information

The infrared remote control must be protected from

moisture.

When the unit is switched on, each change in the

settings is automatically transferred to the air condi-

tioner. A beep indicates that the data has been prop-

erly received.

The transmitter of the infrared remote control must

generally transfer changes to settings in the direc-

tion of the air conditioner.

It is only possible for data to be properly transmitted

if there are no objects located between the transmit-

ter and the receiver unit such as doors, drapes,

blinds, etc.

Never use new and old batteries at the same time!

We recommend removing the batteries from the re-

mote control if the unit is taken out of operation for a

longer period of time.

Remove dead batteries and immediately replace

them with new batteries that meet quality stan-

dards because otherwise they may leak.

Infrared Remote Control Functions

All settings can also be made using an infrared remote

control. A description of the button functions can be

found in the “Control Panel” section. The remote con-

trol’s range is approx. 5 meters.

Two 1.5 V AAA batteries (included in the scope of the

remote control delivery) power the remote control.

1 “ON/OFF” button

2 “MODE” button

3 “TIMER” button

4 “AUTO SWING” button

5 ▲ / ▼ “THERMO CONTROL” buttons

Keep in mind that if there is no plug or it is inserted

incorrectly, water may leak out after the unit has re-

sumed operation.

POWER

on / off

THERMO

CONTROL

MODE

TIMER

AUTO

SWING

reset

set

12 “DRAIN WATER” display

This light indicates that the floating switch of the

internal tank has switched off unit operation. The

internal tank does not become full during normal

operation because the exhaust fan transports the

accumulated and evaporated condensation to the

outside via the exhaust hose. In conditions with

very highs levels of humidity, the moisture cannot

be completely expelled and the unit switches off.

To resume unit operation after it has automatically

been switched off due to a malfunction, proceed as

follows:

1. Switch the unit off by pressing the “On/Off” but-

ton and unplug it from the power supply.

2. Place a suitable container under the condensa-

tion drain of the internal tank.

The condensation drain is located at the bottom

middle at the back of the unit.

3. Pull the plug from the condensation drain and

collect the water that drains out.

4. Then replace the plug.

13 Display

The programmed room temperature is shown on

the display.

The current temperature value is increased or de-

creased by pressing the Up/Down buttons 3 and 4.

If the timer button 5 is pressed, the display switches

to show the remaining hours until the unit is

switched on or off.

If after 5 seconds, no buttons are pushed, the tar-

get temperate appears on the display again.

14 Infrared remote control receiver

If the unit is operated using the infrared remote

control, the impulses are received via the receiver.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

REMKO RKL290 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von REMKO RKL290

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info