Bedienungsanleitung Rika Cooper (Seite 11 von 16) (Englisch)

744702

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

|11

5. MANUAL OPERATION

Combustion air regulation

The performance of your stove also depends on the chimney draught; therefore

the control knob for combustion air regulation must be used according to your

own experience.

Heating-up

position

Middle position Zero setting

100% primary air 0% primary air 0% primary air

100% secondary

air

100% secondary

air

0% secondary air

The primary air intake is absolutely necessary for heating up. The “heating-up

position“ may only be used for heating up.

If the stove is not in use, warm air can release through the chimney. The zero

position of the control knob can largely prevent this.

Note

Sometimes a lot of smoke develops when wood is placed on a low ﬁrebed or

when there is too less fresh air for combustion. An explosive gas/air mixture

may arise and cause an eventual heavy deﬂagration. For safety reasons it is

recommended to leave the combustion chamber door closed and press the

control knob at the rear wall down completely into “heating-up position”. If the

log wood is not igniting, start a new heating-up procedure after it stopped

smoking.

RIKA firelighter

Always ignite the RIKA ﬁrelighter on the red tip. One block consists out of 8 ribs

which can be divided to the desired size. The amount of RIKA ﬁrelighters also

depends on the size and humidity of your ﬁrewood. Ideally, one rib is enough

to light up the ﬁre.

Tip

You can order the RIKA ﬁrelighter with the number E15834 at your RIKA

dealer.

Correct heating up

1. Press the control knob completely into “heating-up position” – primary and

secondary air intakes are opened completely in the heating-up position. Open

the combustion chamber door and clean the combustion chamber from ashes.

Place left and right two small pieces of chipboard lengthways in the bottom of

the combustion chamber.

Place two logs crossways on top of this chipboard.

2. Now place further pieces of chipboard in crosswise layers on top of the logs

and place 2-4 ribs of the RIKA-ﬁrelighter on the left on top of the chipboard.

Some uncoated paper can be placed underneath the chipboard in case there is

no ﬁrelighter available.

3. Now light the ﬁrelighter (or the uncoated paper) and close the combustion

chamber door. “Correct heating up” primarily counteracts excessive smoke

during heating up.

Set the control knob for combustion air regulation to middle position some

minutes later. The primary air intake is now closed and the secondary air intake

is completely open. The control can be set to ideal position another few minutes

later (depending on draught and fuel quality / amount).

After the ﬁrst burn-off, again add two logs (see Amount of fuel). Set the control

to “heating-up position” again until the wood is well lit. Further regulation is

effected as described in Item 3.

Please proceed in the same way for every further addition of wood.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rika Cooper Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Rika Cooper

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info