744712
10
Zoom out
Zoom in
Vorherige Seite
1/14
Nächste Seite
10
Current-free log operation
Please note
Your stove must be disconnected from the mains for current-free
operation.
Please note
Any modification of the procedure stated above may result in
damaging of components, which automatically will void any
warranty claims.
Insert the socket spanner supplied in the sleeve, as shown.
Turn it clockwise until a slight stop can be felt.
Remove the socket spanner from the opening and insert it again in
horizontal position.
Turn the spanner ant-clockwise until it is flush with the marking in
the side panel (approx. 45°). It is now in heating up position.
After heating-up has been successful, turn the spanner anti-
clockwise step by step to reduce the combustion air manually, thus
regulating the burn-off.
Each time logs are added, the spanner must be brought into heating
up positon again. The combustion air is regulated as described
above.
Please note
Always ensure that the stove has enough air for combustion.
Combined operation
Automatic ignition of firewood during start-up, or automatic log
recognition during operation.
Automatic ignition of firewood during start-up:
Place two logs into the firebox. Be sure that at least one of the logs
lies above the combustion trough to facilitate burning. Close firebox
door.
Start stove operation. After ignition has been successful, the
operating state IGNITION switches to LOG CHECK, and after
successful log recognition toLOG OPERATION.
Please note
If no more logs are reloaded, pellet operation starts automatically
again as the unit is still on.
Automatic log detection during operation
Open the firebox door and place 2 logs into the box. Be sure that
at least one of the logs lies above the ignition trough to facilitate
burning.
Close firebox door. The operating state switches from CONTROLLED
OPERATION to LOG CHECK, and after successful log recognition
toLOG OPERATION.
Please note
If no more logs are reloaded, pellet operation restarts automatically
as the unit is still on.
If you switch the combi stove off during log operation, the operating
state will change to STOVE OFF after the logs have burned down.
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Rika Touch Display V2-20 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Rika Touch Display V2-20

Rika Touch Display V2-20 Bedienungsanleitung - Deutsch - 14 seiten

Rika Touch Display V2-20 Bedienungsanleitung - Holländisch - 14 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info