Bedienungsanleitung Roadstar CLR-2530 (Seite 4 von 21) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

592295

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

English English

3 4

the DC 5 V INPUT socket (13) located on the back of the unit.

2. Connect the AC/DC adaptor into a 230V ~ 50Hz AC power

outlet.

Notes:

• Use only the supplied AC/DC adaptor. Using other types of

adaptor may damage the unit.

• Make sure that the AC/DC adaptor matches with your household

voltage before connecting it into the wall outlet.

• Do not touch the AC/DC adaptor with wet hands.

Battery Back-up Power Failure Protection

This radio has a battery back up circuit that will keep the correct

time and alarm settings in the event of a temporary power

interruption.

Install 2 x 1,5-volt battery (type UM4), not included, into the

battery compartment located on the bottom of the unit.

Note:We recommend an alkaline battery for longer usable life.

Change the battery every 9 to 12 months for best result and avoid

possible battery leakage.

If power is temporarily interrupted the display will blink and the

radio will not play. However, the battery back-up circuit will

continue to maintain the clock and alarm settings. When power is

restored the clock will display the correct time and alarm settings,

and no adjustment is necessary.

SETTING THE CORRECT TIME

NOTE: The Clock can be set only if the unit is in Stand-By mode (radio

OFF).

1. Press 2 seconds the SET TIME Button (10) until the display blink.

2. Press the SET HOUR BUTTON / TUNING DOWN (4) button to

advance hour

3. Press the SET MINUTE BUTTON / TUNING UP (3) button to

advance MINUTE until the correct time is displayed.

4. Press the TIME SET Button (11) to complete the setting operation.

SETTING THE WAKE UP TIME

1. Set the alarm time by following this procedure:

2. Press 2 seconds the ALARM 1 / VOL- (6) or ALARM 2 / VOL+ (5)

Button.

3. Press the SET HOUR BUTTON / TUNING DOWN (4) button to

advance HOUR until the correct time is displayed.

4. Press the SET MINUTE BUTTON / TUNING UP (3) button to

advance MINUTES until the correct time is displayed.

5. Press shortly the ALARM 1 / VOL- (6) or ALARM 2 / VOL+ (5) to

finish.

6. Press again shortly the ALARM 1 / VOL- (6) or ALARM 2 / VOL+

(5) button to select BU (Buzzer) or Radio to the activate or

deactivate the alarm type (when ON, the indicator will light up on the

right or left side of the display).

7. To switch off the alarm press repeatedly ALARM 1 / VOL- (6) or

ALARM 2 / VOL+ (5) until tthe indication light disappear.

To review the alarm after set, press and hold ALARM 1 / VOL- (6) or

ALARM 2 / VOL+ (5) button for 2 seconds. The Alarm time will be

blinking on the display. After 5 seconds, it will go back to normal time

display.

LISTENING TO THE RADIO

1. Press shortly the ON/OFF (2) button to switch the Radio ON

manually.

2. Press 2 seconds the TUN DOWN (3) or TUN UP (4) button to start

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Roadstar CLR-2530 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info