Bedienungsanleitung Rommelsbacher CG2308TC (Seite 20 von 24) (Deutsch, Englisch)

713985

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

• Observe the following when setting up the appliance:

Place the appliance on a heat-resistant, stable and even surface (no varni-

shed surfaces, no table cloths etc.)

Place it out of the reach of children.

Leave a ventilation distance of at least 10 cm to all four sides and 1 m to

the top in order to prevent damage due to heat or fat splatters and to grant

that your work area is unobstructed. Ensure a free air circulation.

Never operate the appliance in the vicinity of heat sources (ovens, gas ﬂame

etc.) or in explosive environments where ﬂammable liquids or gases are

located.

Caution – Risk of ﬁre! This appliance is not intended for installation into

worktops.

• Do not use the appliance as space heater.

• Always unplug the appliance after use to ensure a safe switch-off.

Initial use and grilling

• Wipe the surfaces with a damp cloth and dry carefully before using the appliance for the ﬁrst time.

• Ensure that the fat collecting channel is inserted in the appliance.

• Connect the appliance to the mains.

1. Switching on

• The red “operation” LED above the main switch ﬂashes, the appliance is ready for use and in waiting mode.

• Touch the main switch until you can hear the acoustic signal. The red “operation” LED glows and the

display shows a ﬂashing “0” as long as the grill surface is cold. The grill is now in standby-mode.

• NOTE: Should the grill plate still be hotter than 60 °C due to previous usage, the actual temperature is

displayed instead of “0”.

• If there is no further activation within 60 seconds, the display goes out and the control unit will switch

back from stand-by to the waiting mode.

2. Setting the grill temperature and heating-up

• Press the “+” or “-” touch key in the standby mode. The control unit changes to the setting mode and

the suggested temperature of “180 °C” is displayed when initially switching the appliance on.

• NOTE: If the appliance was not disconnected from the power supply since its previous operation, the

former grill temperature is displayed as suggested temperature instead.

• The desired grill temperature can be set using the “+” or “-” touch key. The temperature can be

regulated in steps of 10 °C from 80 °C to 280 °C.

• If no other touch key is activated within 5 seconds, there is an acoustic signal, the “Heating” LED spot

(next to the grill temperature) goes on. Now the appliance is in operating mode and will start heating

automatically.

• As soon as the unit has heated up to the set grill temperature the ﬁrst time, you will hear an acoustic

signal and the “Heating” LED spot goes out. The electronic control keeps the grill temperature

automatically on the set level.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Rommelsbacher CG2308TC Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info