To erase programming from the three buttons do the
1. Press and hold down the two outside buttons until
the indicator light begins to ﬂash, after 20 seconds.
Do not hold the two outside buttons for longer
than 30 seconds.
2. Release both buttons.
is now in the train (learning) mode and can
be programmed at any time beginning with Step 2
under “Programming HomeLink
” shown earlier in this
Individual buttons cannot be erased, but they can be
reprogrammed. See “Reprogramming a Single
Button” following this section.
Reprogramming a Single HomeLink
To program a device to HomeLink
using a HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
Do not release the button.
2. The indicator light will begin to ﬂash after
20 seconds. While still holding the HomeLink
button, proceed with Step 2 under “Programming
” shown earlier in this section.
To reset HomeLink
to default settings do the following:
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to ﬂash.
2. Continue to hold both buttons until the HomeLink
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink
1-800-355-3515, or on the Internet at
2005 - Saab 97X Owner Manual