Bedienungsanleitung Saeco RI 9913- SUP 016 E (Seite 50 von 53) (Deutsch, Englisch, Französisch, Italienisch)

459484

Zoom out

Zoom in

Vorherige Seite

1/53

Nächste Seite

CLEANING AND MAINTENANCE OPERATIONS

key pressed till the desired amount is reached.

Attention: cappuccino amount can only

be programmed if the corresponding

programming function is enabled (see

page 87).

For cappuccino dispensing, fit suction pipe (26) of

the Cappuccinatore (25) in a milk container or in

another container. To prevent milk container

deformation, pierce it on the top to allow air entry.

Place the cup under dispenser (27) and press the

cappuccino selection key.

Cappuccino dispensing can be adjusted by turning

the special Cappuccinatore adjustment valve (28).

Note: it is suggested to use milk with low fat

amounts (1.5%).

For a better cappuccino dispensing, do not

activate the steam (9).

Cappuccinatore cleaning

Let the Cappuccinatore drain a full water container

after each cappuccino dispensing: in this way,

the device will be perfectly cleaned.

Incorporated safety devices

Automatic off

Should the service door be open, the machine

automatically switches off. If the central unit is not

mounted, only water and steam can be

dispensed.

Electronic grinding time control

As soon as the coffee bean container is empty,

grinding automatically stops after 20 seconds

approx. Fill the container with coffee beans, as

shown at page 86.

Electronic pump control

The machine switches off automatically as soon

as the water in the tank is under the minimum level

checked by a special water level indicator (73).

Fill the tank according to the procedure shown at

page 86.

Electronic temperature adjustment

Said adjustment controls the correct temperature to

brew coffee and to dispense hot water and steam.

Coffee brewing is automatically interrupted should

the water temperature be excessive (safety

thermostat and overheating safety device

activated).

Antigravel device

Even selected coffees may contain impurities.

To avoid damages, the coffee grinder is fitted

with an antigravel device against impurities.

Should gravel end up into the coffee grinder, you

will hear a strong and characteristic noise. Stop

the machine immediately otherwise the machine

will automatically stop within 20 seconds thanks

to the special electronic protection system.

Important: Do not start the machine before

the foreign body has been removed, otherwise

the motor may be damaged. Procedures: see

page 85, points 45-49.

Cleaning and maintenance

operations

General cleaning

To ensure a good coffee quality and a longer

working life, always keep the machine clean.

Before cleaning the machine, turn off the main

switch, unplug the machine and wait until it

cools down.

Do not immerse the machine into water or other

fluids: it may be irreparably damaged!

Do not wash parts of the machine in the

dishwasher!

Always handdry all parts of the machine, do not

dry them in the oven or microwave oven!

Water tank, drip tray, coffee grounds

container and coffee dispenser

In order to keep the service area and the central

unit (22) clean, daily empty the coffee grounds

container (1), after machine use.

The water tank (11), drip tray (2), cup holder grill

(3) and coffee grounds container (1) should be

washed periodically, using a non-abrasive solvent

and drying them carefully.

Coffee dispenser (4) may be removed for cleaning

operations. Unloose the screws and rinse the

dispensing tube thoroughly with hot water.

From time to time, clean the machine casing with

a damp cloth and dry it.

Clean pre-ground coffee container (14) with the

aid of the brush supplied, whenever necessary.

Central unit

Clean central unit (22) whenever the coffee

bean container is filled, or at least once a week.

Switch off the machine and open service door

(19). Remove grounds coffee container (1).

Remove central unit (22), by holding the handle

and shortly pressing the PRESS key.

Wash the central unit with hot water; do not

use any solvent.

Make sure there are no coffee residues on the

two steel filters: the upper filter can be removed

by unloosening and turning the plastic pin

anticlockwise using the tool supplied.

Dry thoroughly each central unit component, fit

the filter again and tighten it properly with the

screw .

Remove coffee rest drawer (23) and clean it,

using a non-abrasive solvent.

Clean the service area thoroughly and fit the

coffee rest drawer again.

By holding the central unit by its handle, slide it

back into its original position, making sure it is

correctly engaged. Then close the door. Fit the

coffee grounds container again.

When fitting the central unit, do not

press “PRESS” button: it may cause

irreparable damages to the machine!

Warning: if the central unit is not correctly

fitted, the following message will be displayed:

"BREW UNIT MISS "

The machine cannot dispense coffee.

Coffee grinder

Never fill the coffee grinder with water: it may

irreparably damage the machine!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Saeco RI 9913- SUP 016 E Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info