Bedienungsanleitung Sagem D20T (Seite 25 von 32) (Englisch)

521531

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Care and Maintenance

Use a slightly damp cloth to wipe the base and handset as well as charging contacts, do not

use a dry cloth as this may cause electrostatic charges.

Problems

Refer to the table presented below in case of an operational malfunction:

Problems Remedies

The base indicator light is not lit Make sure that :

• the power adapter is properly connected to a power socket.

• the power connector is properly plugged into the base.

• your fuse and circuit-breaker are in working order and that the power

socket is powered.

The handset display is blank Make sure that the batteries are properly installed.

Place the handset on the base and fully charge the batteries.

To increase the life of your batteries, you can perform this operation about every

two months.

If these precautionary measures do not resolve this issue, replacement

batteries are available through your reseller.

As time goes by, you may notice a slight decrease in battery performance. Use

your handset until the battery is fully discharged, and then charge it for at least

6 hours.

Note: as time goes by, you may notice a slight decrease in battery performance.

Use your battery until the battery is fully discharged, then charge it for at least 6

hours. Fully discharging the batteries at least once every two months will help

them to last as long as possible.

The handset does not ring

during an incoming call

Make sure that the telephone is properly connected and that you have a dial

tone.

Make sure that your telephone is not set to silent mode (refer to paragraph

Modifying the default handset melody volume, page 15).

No radio link between the

handset and base

The network indicator icon

flashes

Make sure the handset is registered by moving closer to the base, if it is

registered correctly, the handset screen should display its own handset number.

Otherwise, register the handset to the base (refer to paragraph Registering a

second handset to a base, page 21).

Programming not possible You have already logged in two handsets. You must delete one handset first

(refer to paragraph De-registering a handset, page 22).

Radio Interference occur during programming, retry the programming, if

possible move closer near the D20T base station.

Interference during

communications

Out of range or close to other electrical appliances :

Check the handset is not emitting the out of range warning tone. If close to

other electrical device move away. You may need to reconsider the location of

your D20T Base if this problem persists.

Entries will not be accepted in

the DIRECTORY.

Directory is full :

Up to 25 names and numbers can be stored in the D20T Directory. Delete some

of the older entries to make more space for new one.

APPENDIX

LU 251619615_D20T_GB_SAGEM.book Page 23 Jeudi, 26. août 2004 4:54 16

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sagem D20T Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sagem D20T

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info