Bedienungsanleitung Sanitas SGS28Q (Seite 4 von 8) (Deutsch, Englisch, Französisch, Spanisch)

626693

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

– The device is only for private use and is not intended for medical or commercial purposes.

– On delivery the scale is set to the unit “kg”. A switch located on the back of the scale enables you

to change to “pound” and “stones” (lb, St).

– Please dispose of the appliance in accordance with the Directive 2002/96/EC on Waste

Electrical and Electronic Equipment (WEEE). In case of queries, please contact the munici-

pal authorities responsible for waste disposal in your area.

3. Use

This scale is used to determine the weight of human beings. The scale has a weighing range up to

330 lbs (150 kg).

3.1 Batteries

If present, pull the battery insulating strip off the battery compartment cover or

remove

the battery’s protective film and insert the battery according to the polarity.

If the scale

fails to operate, remove the battery completely and insert it again. Your scale is equipped

with a “replace battery” indicator. When the scale is operated with a battery which is

too weak, “Lo” appears in the display field and the scale automatically switches off. The

battery must be replaced in this case (1 x 3 V lithium battery CR2032). The used, com-

pletely drained standard and rechargeable batteries must be disposed of in specially

marked collection containers, at toxic waste collection points or electrical product re-

tailers. You are legally obligated to dispose of the batteries.

Note: Batteries containing pollutants are marked with the following symbols: Pb = Bat-

tery contains lead, Cd = Battery contains cadmium, Hg = Battery contains mercury.

Place the scale on a firm, flat surface; a firm floor covering is a basic requirement for

correct

weight measurement.

3.2 Measuring weight

Place the scale on a firm level floor (no carpet); a firm floor covering is

required for correct measurement.

Audibly, briefly and firmly tap the scale with your foot to active the vibration

sensor! The entire display (Fig. 1) appears up to “0.0” (Fig. 2) as a self-test

(tap-on technology).

Now the scale is ready to measure your weight. Stand on the scale without mov-

ing about and distribute your weight evenly on both legs. The scale immediately

begins to measure your weight. The scale switches off 10 seconds after you step

down from it. The measuring result remains visible during this time.

If the scale detects an error during weighing, “Err” appears in the display (Fig. 4).

Make sure that you always switch on the scale first and wait for the display “0.0”

(Fig. 2) before stepping on.

Français

Lisez attentivement ce mode d’emploi, conservez-le pour un usage ultérieur, mettez-le à la dis-

position des autres utilisateurs et suivez les consignes.

1. A savoir

Pour bien se peser

Pesez-vous, si possible, à la même heure (de préférence le matin), après être allé aux toilettes, à jeun

et nu(e) afin d’obtenir des résultats comparables.

2. Consignes importantes –

à conserver pour un usage ultérieur!

8888

Fig. 1

0.0

Fig. 2

Fig. 3

Fig. 4

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sanitas SGS28Q Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info